Turn signal wiring diagram for 1994 honda civic dx

SOURCE: How to change upper control arm on 1996 Honda Civic DX ?

UPPER CONTROL ARM:

Do not disassemble the upper arm. If the ball joint or bushings are faulty, or the upper arm is damaged, the entire upper arm must be replaced.

1. Raise and support the vehicle safely.
2. Remove the front wheels. Support the lower control arm assembly with a floor jack.
3. Separate the upper ball joint from the steering knuckle using a ball joint separator tool.
4. Remove the self-locking nuts from the upper arm anchor bolts. Remove the upper arm from the vehicle.

1. Install the upper control arm assembly into the strut tower.
2. Connect the upper ball joint.
3. Install the front wheels and lower the vehicle.
4. With all four of the vehicle's wheels on the ground, torque the upper control arm nuts to 47 ft. lbs. (65 Nm). Torque the castle nut to 32 ft. lbs. (44 Nm); then, only tighten it enough to install a new cotter pin.
5. Tighten the wheel nuts to 80 ft. lbs. (110 Nm).
6. Check and adjust the vehicle's front end alignment.

1. Remove the lower control arm that is in need of new bushings.
   

1. Set up the control arm in a press.
2. Using a impact socket of the correct length and size, press out the old bushing.
3. Install the new bushing by slowly using the press to push it into the control arm.
4. WARNINGExcessive force could cause the bushing to bend or tear so be careful.
5. Once the bushing is properly seated in the control arm, remove the arm from the press and install it on the vehicle.

SOURCE: 1994 Honda Civic Ex Heater doesn't work. Thermostat does

check your fuses

SOURCE: how to remove transmission on 97 honda civic dx

remove crossmember, axles, cables, tranny mount bolts (3), tranny to engine of course bolts

Go to autozone.com and register for full free online repair manual

SOURCE: honda civic vtec 1995 - 1998 engine wiring diagram

Go to your local library and ask the Librarian to get you on-line to the Automotive Repair Reference Center, and then to the EBSCO database...you will find all of your wiring diagrams there.

SOURCE: where is the fuel pump fuse located on 1994 Honda

Fuel pump is in the tank, there may be an access panel under the back seat area. One thing to check is the Main Relay. Ususally up under the dash, Left Dash area, I dont have a diagram, but you will need one to find and verify the relay operation.