2000 Jeep Grand Cherokee Laredo Door Locks Dont' Work Correctly

RTM, read the manual, get one buy one or open glove box and read.?
child LOCK?
are you talking about the door looks
or the child tether>?
i cant guess try telling what dont work first and how you tried.
first.
door child locks are an option, on new car

this?

Sounds like you have a bad module or the master switch on the drivers side door is bad

A bad connection at the speaker or the unit could be a problem. Burned out amp section as well.
This may help.

It has to be the switch or the wiring, right? So pull out the switch and probe the back with a volt meter to see if power is coming out of the switch. If yes, trace the wires to the doors.

look inside the rubber boot inside the drivers door, one of the wires is probably broken splice back together. Welcome to the wonderful world of jeep problems.

sounds like an open power or ground circuit on passenger side,since the door lock and the window,lost its functioning.Both switches would have to be bad at the same time,which is not probable, to be the fault. Unless there is a saftey lock out switch on the drivers panel,controling the passenger side door lock and window.

There are broken wires in the wiring harness between the frame and your driver's side door. These wires control all the windows and door locks in a 95 Jeep. Same thing happened to me. You will have to cut the rubber boot to get it off and check which wires are broken and repair them.

driver side lock and window switch... if its all one unit... i had a 95 cherokee laredo that did that... changed the switch and it fixed my problem...

There is a broken wire in the rubber casing between the door and the vehicle. Take the rubber casing off and you will more than likely find a broken wire or one about to break. Been there and done that.

I have a 2000 Jeep Grand Cherokee the power windows,power seat , door would not lock , and the inside lights would stay one ..i thought it was a fuse problem but no fuses for that ... in the rubber boot between the door and frame ..the was the ground wire was split ... put a **** connector on it everything works great now ....