My 2005 nissan altima 3.5 is idling at 800 rpm's, and my service engine soon light came on. The code read for a Chrysler? P1283, and Fuel pump module detected an incorrect low idle, low idle select circuit open & shorted,ECM defective, and fuel injection pump fault. They car has cut off while driving before, and idles rough at times. The light has come on when I fill the tank too. I recently replaced the bank 2 sensor. Any thoughts for a resolution?

Marvin

• 85242 Answers
• Posted on Sep 17, 2008

SOURCE: nissan ga15 engine idle adjustment locations

The idle speed is computer controled, it is not adjustable, you most likely have sludge in the throttle valve and the idle speed control air bypass valve, clean them with carb spray with the engine running.

SOURCE: 1996 Nissan Sentra Idles Roughly, Cuts Off, Engine Light Stays On

if this is an automatic there will be a dip stick if it is a manual you do not use transmission fluid to find out what sencor is bad take car to advance auto parts they have a digatal reader and can tell wou what sencer went bad and where it is located

SOURCE: Car Stalls at low speed. Restarts. DTC Code 0340 and 1167

The codes you provided indicate separate issues. Code 1167 is indicative of either a stuck fuel injector of the O2 sensors. Code 0340 indicates the CMP position sensor. Replacing the O2 sensors will likely clear the 1167 code assuming the fuel injectors are okay. It would be the first course of action. If there's no noticeable change in performance (i.e. stalling problem continues) then the CMP position sensor is likely your overall problem. Best of luck.
Greg

SOURCE: my 1995 Nissan Altima idles rough when at a stop

change ur Airflow sensor buddy. thats the only problem. And if yet it doesnt work then check ur crank sensor....

SOURCE: my 2003 Nissan Sentra spec v dies when idling

try replacing the crankshaft and camshaft sensers, my 2004 sentra spec v had the same problem.It cost me $122 for both the sensers and can be done in 20mins