The unit stopped working when transferring a call re bluetooth only static.
then all the electronics associated with uconnect would not respond properly to commands. i think it has to due with the connections of the electronics of the computer control. however i do not know where to find them nor how to test
SOURCE: 1999 jeep grand cherokee loredo 4x4
The transfer case is no longer a simple device controlled with a single manual stick shifter.Just like the engine and trans,fuel system,exhaust system,electrical system...etc etc....It is a complex electrical world/circuit all unto itself.There are approximately 2 sensors,two switches,and an electric MOTOR and a computer,that all work in unison to provide the luxuries of "shift on the fly" transfer case abilities.As a complex electrical system,it must be diagnosed as such.Basic steps in diagnosing a problem follows in order of sequence....1:pull Diagnostic Trouble Codes (DTC)'s from the transfer case system 2:For every dtc is a diagnostic route to verify all the electrical sensors and controls and COMMANDS are in place anf functioning. 3: If all external electrical componenets are tested and verified functioning,the last diagnosis is 4: Internal transfer case failure.
SOURCE: uconnect auto pairing
Check with jeep.com/uconnect to make sure it is compatible. The phone is the problem 9 time out of 10. The cell phone provider can upgrade the software to make it compatible with the uconnect.
SOURCE: Uconnect has stopped working completely. will not activiate.
when i press the voice recognition button or the the phone button on my steering nothing works not even sound
139 views
Usually answered in minutes!
×