SOURCE: 2005 GMC Sierra Overheating
If your sure there is no trapped air in system after refill and air bleed off, is fan clutch pulling good air thru radiator? Even if it is, the heater should have coolant as hot as what temp gage is showing! Try backwards flushing heater core (dex cool is notorious for plugging these up). There is a TSB for cracked cylinder heads from GM for unexplained coolant loss.Remove drivers side valve cover, and look at center three head bolts for coolant around them, if coolant has been getting in thru this suspect area, there will be a milky/pudding like goo under valve cover and on head. GM had a company called Castec cast these and the areas near the head bolts were found to be too porous (NO recall YET!) Ya, you guessed it, replace heads! Unfortunately, if its gotten hot to many times, it has probably hurt the heads/gaskets. Hope this helps. PS: The castec logo is under the rearmost pair of rocker arms,may have to remove them to see.
SOURCE: 94 GMC truck diesel starts,runs and then dies and will not start
I have the same problem and have trouble codes 35 and 36. I found out that there is a computer module that needs replaced as it sits low in a valley and gets hot and seperates. I am reseaching about the a/m fix that installs the new module away from heat.
SOURCE: 1997 GMC Sierra Ignition Switch Replacement
take off the cover on the top and bottom of the steering column just behind the wheel. pop the tilt lever out simply just by grabbing it and give it a good tug. then once you have the new switch and you get in there your going to need an inverted torx socket to remove the small bolts that hold the switch to the column. do not move the gear on the new switch make sure it lines up exactly as the old one did!!!!!!!!!!!!
SOURCE: 2004 GMC Sierra 4dr truck. the fan does not work
The switch or the wire harness at the blower motor has gone bad. The highest setting 5 has no resistor, so the blower runs on high but the high current flow ends up burning up the switch's contact on that setting or the resistor wire harness at the blower motor has gone bad. Common would be the switch it self, if the switch is good. Then it's going to be the wire leads at the speed resistor by the blower motor under the glove box by the passenger leg compartment. Keep me posted, be glad to help you get your Sierra running 100% again soon.
SOURCE: how to fix horn in
if the relay clicks then got to the horn and check for voltage at the wire, then ground to horn, if all is good replace horn
235 views
Usually answered in minutes!
×