1995 GMC Jimmy Logo

Related Topics:

alan swensen Posted on Sep 01, 2013
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Starter motor fialed - 1995 GMC Jimmy

1 Answer

jim sharp

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

  • GMC Master 987 Answers
  • Posted on Sep 01, 2013
jim sharp
GMC Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Master:

An expert who has achieved Level 3.

Joined: Jul 22, 2012
Answers
987
Questions
1
Helped
181912
Points
2541

What do you need to know

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

Car turns on but wont go in drive

You have a fialed transmission, it will need to be removed and rebuilt.
0helpful
1answer

1997 Buick Lesabre...can not open pssenger front door from the outside, any suggestions? any suggest

remove the door panel and see if the rod feel off or the lock assembly fialed
0helpful
1answer

20000 elantra wagon that is shifting hard in drive and will not go in reverse

YOU HAVE A FIALED TRANSMISSION, THE NO REVERSE IS THE KEY SYMPTOM OF THIS.
0helpful
1answer

My truck will not start and lights are on the dash

In most cases this means the battery has fialed.
0helpful
3answers

Was driving fine ..parked the car went in the store came out and all i get is a clicking when i turn the key

check the battery and connection if they are good then replace the starter it is bad, you can try having someone tap on the starter while cranking it over it may start but the starter is still bad, hope this helps.
2helpful
1answer

Replace an alternator on a 2005 chevy venture (instructions)

REMOVAL PROCEDURE

IMPORTANT: This vehicle uses the PG260 F1 starter motor. The starter motor is serviced only as a complete unit.

  1. Disconnect the battery ground (negative) cable from the battery.
  2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
  3. Remove radiator air baffle assembly.
  4. Remove the starter motor BAT terminal nut and electrical leads.
  5. Remove the starter motor S terminal nut and electrical lead.
  6. Remove the torque converter co
  7. Remove the starter motor bolts.
  8. Remove the starter motor.
INSTALLATION PROCEDURE
  1. Install the starter motor.
  2. Install the starter motor bolts. Tighten the starter motor bolts to 47 N.m (35 lb ft)
  3. Install the torque converter cover.
  4. Install the starter motor S terminal electrical lead and nut. Tighten the starter motor solenoid S terminal nut to 3 N.m (27 lb in).
  5. Install the starter motor BAT terminal electrical leads and nut. Tighten the starter motor solenoid BAT terminal nut to 10 N.m (89 lb in) .
  6. Install radiator air baffle assembly.
  7. Lower the vehicle.
  8. Install the battery ground (negative) cable to the battery.
0helpful
1answer

Ac cold only on passenger side

A common cause for this is low freon charge. First step would be to have the freon removed and measured to see if the correct amount was in. If this is not the case, then the drivers side temperature door actuator motor may have fialed.

Not finding what you are looking for?

24 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...