SOURCE: Cam belt or timing chain ?
Dont know for pos, but almost all new cars have timming belts. except for v8s and a few v6s
SOURCE: need a serpentine belt diagram for 2005 ford focus
You should have that diagram on the inside of your hood or on the fan shroud. Good luck
SOURCE: Need info on a 2005 Ford Focus 2L TDCI
2005 Ford Focus L4-2.0L VIN N
Hello your vehicle has a timing chain, you do not have to replace it ever... It was designed to last the life of the vehicle, unless you have a water pump, or a timing pulley or even a timing tensioner go bad, that is when you would service the timing chain. I added what your vehicle needs at it's 90,000mile service below, hope this helps... (subytech1)
Inspect
Ball Joint
Brakes and Traction Control
Inspect brake pads, shoes, rotors, drums, brake lines & hoses, and parking brake system.
Cooling System
Inspect cooling system and hoses.
Exhaust System
Fluid - A/T (Except 4F50N & 4F27E)
Inspect automatic transmission fluid level on all other vehicles, if equipped with dipstick.
Heat Shield, Exhaust
Steering and Suspension
Inspect steering linkage and suspension.
Vehicle (Multi-Point Inspection)
Perform Multi-Point Inspection (Recommended by Ford) Refer to Routine Service.
Wheel Bearing
Inspect wheel ends for endplay and noise.
Replace
Cabin Air Filter
Replace cabin air filter, if equipped.
Engine Oil
Fluid - A/T (4F50N & 4F27E Only)
Change automatic transmission/transaxle fluid on all vehicles
equipped with 4F50N & 4F27E. Inspect automatic transmission fluid
level on all other vehicles, if equipped with dipstick.
Fuel Filter
Oil Filter, Engine
Rotate
Tires
Testimonial: "Thank you that really helped"
SOURCE: fuel pump replacement on 2005 ford focus
Are you sure that you need to replace the pump? I drive a 54 plate mk2 1.6 zetec that wouldn't always start and I was told it was the fuel pump in the tank but because the fault was intermitant I didn't have it fitted and found out that the car didn't start because the fuel lift pump wasn't priming the system before starting. I found that there was a faulty connection on the relay for the pump that is in the compartment under the glove compartment.
612 views
Usually answered in minutes!
×