I have a 2003 dodge ram 1500 5.7l hemi. Last night i tried to start it and the key wont turn, the steering wheel wasnt locked, and i tried for a half hour to get it to turn, this has happened once before, and i got it turn and start after wiggling the key in there for 5 min and turning wheel as hard as i could, but its not working this time. took it to autozone because check engine light was on, and they said it was the ignition coil. The key goes in but it just will not turn its like the ignition is locked. What do i do to fix this?. Should i change the ignition coil, will that solve the problem.
SOURCE: 2005 Ram 1500 4wd HEMI PO406 - EGR
Hey greenlee99, your best bet would be to grab one these manuals so that you have pictures and diagrams along with step by step instructions. It will tell you what tools and parts you need. Can't go wrong with having it.
SOURCE: 2004 ram 1500 hemi 5.7 alternator
You need to release the belt tenion before, removing the alternator. The engine is equiped with auto tenioner.
SOURCE: how do i change the power steering pressure switch
From the Factory Service Manual, you can get one relatively cheap from www.promanuals.net. Here is a link to your 2004 Dodge Ram Service Manual.
The power steering pressure switch is installed in
the power steering high-pressure hose (Fig. 9).
(1) Disconnect electrical connector from power
steering pressure switch.
(2) Place a small container or shop towel beneath
switch to collect any excess fluid.
(3) Remove switch. Use back-up wrench on power
steering line to prevent line bending.
SOURCE: problem with starting my 2003 dodge ram
My father has the same problem with his 2001 Chrysler Sebring, the key will go into the ignition switch but wont turn. Called the dealer and seems the tumblers inside the ignition have gotten stuck, the solution... put the key in the ignition and tap it gently with a hammer (plastic tip if you have it) and it worked fine. Not sure what the guys at Autozone are pull but on a Ram 5.7 Hemi there are individual coils, not one, I should know I also have a 2003 Ram 1500 and have changed the plugs (not fun)... I have a code scanner (Hypertec) and when I've gotten a check engine light I check it with the scanner. Turned out mine had a problem with the air sensor in the intake. $15 part fixed the problems. Good Luck.
SOURCE: replace timing chain on 03 dodge ram 1500 with 5.7 hemi
i have an 02 and i purchased a repair manual from autozone
1,165 views
Usually answered in minutes!
i got a problem where my truck can be running and i can walk away form the with WITH KEYS IN HAND and yeah... when i shut the truck off it don't shut all the way off and its killing my battery...
×