SOURCE: remove windshield washer reservoir
Take off the wheel well shroud. Firdt remove the front right wheel, it will be easier. Then remove the two screws holding in the tank. Remove the two electrical connectons and small rubber hose. Next (or first) grab the filler tube and twist while pulling it from the tank as it is held in by a rubber gromet. Then pull the tank forward and let it drop down. Nothing else is holding it in except the two screws. Removing the filler tube is a must!
SOURCE: terrano gearbox keeps jumping out of overdrive and
Nissan Terrano's have an Electronic Computer that controls the gearbox. It is hidden behind the left hand rear Speaker box, right hard up against the rear seat back rest. This system controls all functions regarding the gearbox and it's rev rates. If your vehicle is shifting back on long drives then it is possible that the computer sees any slight increase in revs as a desire to "Kickback" the gearbox to a lower gearing, hence it dropping out of overdrive. Unfortunately a gearbox specialist with a computer "Plug-in" is needed to fix this, but it is fixable. This problem should not be too expensive in comparison with a new gearbox.
SOURCE: change brake light bulb on a 2000 Nissan Frontier
The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.
SOURCE: 2005 nissan frontier se 4.0 No start No spark.
Ignition Control Module is the Obvious Problem here
SOURCE: nissan frontier 2001 has spark and fuel cranks but
my truck won't start but .. no click just a little kinda grind and then stop .. is it the starter ?
77 views
Usually answered in minutes!
×