Could be the ignition switch. It's definitely an electrical problem, and the ignition switch is the most likely cause.
I agree, it is an electrical problem. It could be the ignition switch, or even the PMC. There is know way of knowing until you check the DTC chart or system chart on AllData, and run a pinpoint test. It would be cheaper for you to take it to a good shop. You don't want to replace unneeded parts, and that's what you'll do trying to fix it. I mean no disrespect. But I've seen people that are pretty good DIYers make the same mistake.
×
Some have a relay that is soldered directly to the fuse panel under the hoid,to access it you must take apart the fuse box!!
SOURCE: I have a 2000 dodge ram 1500 sport 5.9. I was
Cmp And Ckp are your cam and crank sensors. Basically whats going on is one of those sensors are malfunctioning causing the system to adjust its resources. ie the pcm guesses how fast the cam or crank is turning and adjust timing as nessessary. Pull the crank sensor and inspect for damage. do the same for cam. You may need a book for there locations. Also using a test meter, check there output signals for correct voltage. This should point you in the right direction. Hope it helps.
SOURCE: dodge ram 2500 2000
You need the main wiring of the car and fuses there broken wires or the connector which is causing this problem.........
SOURCE: intermitent no bus problem on 2003 dodge 1500
check all relays .. relays after getting hot will shut off what ever they run.. so check them closely .. they are in your power distribution box under the hood and the lid usually has a diagram of which is which.. Relays are good at cooling off and working right a while too so look these over . or change the ones you think are the right one.. thanks Jerry
SOURCE: Truck stalls while driving down the road.....
SORRY but you have a very typical dodge problem.dodges are VERY well known for these little and big wiring problems.you can find an electrical expert thats highly recomended or the dealer.if you don't fix it well,my grandads had some small problems fuel hand radio insturment panel would all stop working some times and some times work fine,then one day it burned the whole harness inside truck and under hood then it really cost a pretty penny.hope you get her fixed..
4,343 views
Usually answered in minutes!
×