SOURCE: need torque specs
Valve Rocker Arm Bolt 19 N·m + 30° (14 lb ft+ 30°)
A GM dealer shows me another source, which says 32 Nm (24 lb-ft). Not sure which one is right but they screwed up my car.
SOURCE: Need the correct torque specs for 2004 silverado 1500 calipers
hope this helps
SOURCE: torque specs for 2000 chevy silverado truck 4.3 v-6 engine
Not sure what torque spec's your looking for.
Go to www.AutoZone.com, enter your vehicle information and check specifications. You should be able to look up the torque spec's your looking for.
Good luck.
Regards,
SOURCE: how do i change my upper and lower ball joints
Jack up the car remove wheel remove brake caliper and remove rotor rent a ball joint press remover and installer tool (at schucks you get money back when you bring it back) if it's 4 wheel drive you will have to remove the axle shaft next pull the snap ring off on the top side and put tool on the lower tie rod end and press out, next do the top press out top joint next sand ball joint sockets so it is clean lube with WD-40 next press in top ball joint and then lower ball joint. In this order otherwise you will have to un install the top ball joint by removing the pin then nut.
766 views
Usually answered in minutes!
×