You will need to remove the steering wheel...using a steering wheel puller, or a harmonic balancer puller...the turn signal switch is under the steering wheel...unscrew hold downs, trace wire from turn signal switch to under the dash behind the brake pedal, disconnect the connector wire...re-install pulling wire up from floor to inside the steering wheel...sometimes tying the wire to another object, then pull through...hope this helps.
SOURCE: firing order for 1989 full size ford bronco 302
13726548 #1 cyl is front pass side and count to back 1234 are on pass side.5678 are on driver side.# 5 being front
SOURCE: 1989 Bronco starts but dies after a couple of seconds
try checking the thermostat control senser. it caused my bronco to start for a second and then die. after a while it would finally start and run for a while then die driving down the road. i changed the thermostat control senser and it fixed all problems of dieing
SOURCE: removing neutral safety switch
Check out the autozone website at autozone.com and register your vehicle. It is free and will give you access to an online repair manual for the vehicle. The steps for removing the neutral safety switch can be found there. Hope this helped. Best wishes.
161 views
Usually answered in minutes!
×