I recently purchased a 2004 Suzuki Aerio and it came with the remote start and remote start. Neither one is working! I replaced the battery in the remote and it made no difference. If I click the button to unlock the doors, the lights flash but nothing happens. Does anyone know how it works or if I should be doing something to make it work?
SOURCE: How do I program my new Suzuki keyless entry remote to work with our new SUV?
I bought a remote the other day and got these instructions with it. They worked!
1. Make sure vehicle is in Park
2. Press Vehicle Information button (has the icon of a car and an 'i')until 'PRESS *check mark* TO RELEARN REMOTE KEY' displays.
3. Press set/reset button. The message 'REMOTE KEY LEARNING ACTIVE' will display.
4. Press and hold the lock and unlock buttons on the transmitter at the same time for about 15 seconds. A beep will sound indicating that the transmitter is matched.
5. To match additional transmitters at this time, repeat Step 3. Each vehicle can have a maximum of four transmitters matched to it.
6. To exit the program mode, you must cycle the key to LOCK.
SOURCE: I PURCHASED THIS 2004 AVIATOR USED WITH NO KEYLESS ENTRY CODE.
the keyless code is by the right rear door panel. open the door, remove the panel that's over the the seatbelt. after doing that open but you don't have just kind of stretch out and their you will find a black box or reciever with a sticker and a 5 digit code stamped on it. if you want to change the passcode refer to your manual, but you'll need the original code to be able to change it.
SOURCE: suzuki aerio engine 2.0L have timming belt or chain?
TIMING BELT SHOULD BE 60,000 MILE CHANGE
SOURCE: how to change keyless entry code when I don't know the current
Open the right/rear door. Pull the rubber weatherstrip back from the door opening. Fold the right/rear seat back down into a locked position, in order to access to the right/rear trim panel. Carefully, pry the right/rear upper trim panel housing the right/rear seat belt height adjuster. Now carefully pry back the lower trim panel taking care now to break it, exposing the vehicle security module with three connectors plugged into it, coloured green, blue, and grey. Look on the label that has the part number which should end in EB. There are FIVE numbers to the right of that number. Those five numbers are your keyless entry keypad code.
SOURCE: my 2004 suzuki aerio would not start last year. I
your comp is not reaspondig/acting the way it shoud so until everything is new it aint gunna start because it only starts wen u put something new comeone just think about it
310 views
Usually answered in minutes!
Sorry meant to say it came with a remote starter and keyless entry. Thanks
×