Look for a part of that wire cable that is rubbing on metal somewhere or that some mechanic pinched under a bolt or drilled a screw through. It may take some time but the closer you look at that wire from end to end the faster you will find the problem. Blowing a 30 amp fuse means something is shorting out pretty good so go find the short.
If you need further help, reach me via phone at https://www.6ya.com/expert/lloyd_4256582adacd68ee
SOURCE: How to tighten side mirror. 1996 dodge ram 1500 manual mirrors
take door pannal off there should be 3 bolts in the inside of the door where mirror sits unless its the reflection peace where you have to just get a new mirror
SOURCE: dodge ram 1500 engine rpms surge at freeway speed
those sensors could cause the issue, clean the MAF 1st, also clean the idle system using the following procedure, the IAC can cause cruise surge. I use this to cure these problems all the time.
Here is the most common cause of surges and stalls and low idle, it is the idle speed control air-bypass valve (IAC) and throttle valve, they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.
SOURCE: Location of O2 Sensors on 1996 Dodge Ram 1500 ?
Follow your exhaust manifold down from engine to exhaust pipes etc, you should see them sticking out, 3"-4" approx.length, with wires coming from them. Some are right on manifold, some further down on exhaust pipes.
SOURCE: 2002 Dodge Ram 1500 power door locks keep blowing fuse
by process of elimination!
one door at a time so disconnect 3 & keep changing the active one till you find which one isnt working
then test its circuits ok
Cheers rob.
960 views
Usually answered in minutes!
×