Make sure they put it on a comperter to check the codes and all senser as well as the o2 Sencer
sensors.
scan first leap second.
if he has transmission codes, 02 is not it.
1993 rodeo is not a 2004
×
Answering hi-jakker
Jaccar wants more answers to this question
the 2002??????
fire your mechanic
he is incompetent.
find a real ASE shop and win. I promise !
the lamp means
scan me.!
using a scan tool. of any kind. (modern OBD2)
the lamp means there are serious problems. and or smog fails,most times SAME.
the problem can be as simple
as a loose gas cap.
really
or you skipped tuneups, the 60,000 mile is important.
there are 100 possible causes
the Book on the car tells you that if you read it.
"the service manual" on all cars show that.
fire you mech, for sure.!
×
SOURCE: isuzu rodeo sport 4wd, stuck in 4wd
Don't know if this will help with your exact problem, but I can share with you how I have "fixed" this.
If the 4WD indicator is flashing, then it means the 4WD select switch is working but the 4wd "clutch" hasn't released. Backing the vehicle up slowly, or sometimes just switching into reverse with the 4WD switch in the 2WD position is usually enough to release the 4WD and the 4WD indicator should go off. It after all this, the indicator still does not go off, it could be some issue with the electric 4WD clutch not releasing.
You should be able to tell if the 4WD drive is still engaged by driving slowly in a circle. On drive pavement, the front wheels will "hop" around. Don't do this too fast or too often on drive pavement, since the part time 4WD was not meant for this. The front wheels have to be able to slip in relation to each other, when in 4WD.
Hope this helps and wish you well in your troubleshooting.
SOURCE: 2000 Isuzu Rodeo Check Engine Light
After you change the gas cap like everybody tells you. The transmission position micro switch on the floorboard.
SOURCE: how to check transmission fluid on 2001 isuzu rodeo
There is no dipstick on your auto trans. Checking it is a real PITA The trans pan has 2 plugs in it. The one on the very bottom is the drain. The one in the corner, up higher in a recess is the check/fill plug. To check, the engine must be warm and running, tranny in P. Remove the plug and fluid should dribble out. If it doesn't it's low, fill until it dribbles out, while engine is running. Obviously the truck must be on a lift or up on jackstands.
SOURCE: Check engine light-isuzu rodeo
Gas cap isn't on right. Remove and retighten. Turn it at least 5 times.
SOURCE: Dash Lights 1995 Isuzu Rodeo
with lights off and battery disconnected remove the twist knob on the dash that brighten and dims your dash lights and jump the two prongs with a jumper wire. connect battery and turn lights on all your dash lights should work now. if thay don't take the dash screws out and replace the bulbs, it's really easy if you have mechanical skills if not consult a friend that does. now you know the dash light dimmer switch is bad and they are hard to find i found mine in a wreck but until i did i just left the jumper wire in place (about a year and 1/2)
138 views
Usually answered in minutes!
Had the same problem with "Check Engine" light.
If fuel cap in not on tight enough with three clicks it will come on. If the fuel cap is defective and does not seal even though you would think it has. Buy a replacement one. After replacing cap restart vehicle three or four times and the "Check Engine" light will clear. This has always worked for me. If not then disconnect one battery cable wait 3 minutes and then reattach battery cable.
×