SOURCE: Changing of front wheel bearing
i assume u want to both inner and outer bearings...you have to pull the whell off the caliper for the brakes has to come off,there will be a center cap on the hub,,take ot off,inside there you will find a nuts with a cotter pin in it.remove it.gently pull on the hub abd iit should come off in your hands.the outer bearings will come out always remember to repack them with grease before you replace them the inner bearings will be behind the rotor and will have to be chanfed also as well as greased,you have to do this on both sides the same process.put it back together the same way you take it apart
SOURCE: wheel bearing installation
Unless you have the proper tools, specifically a large bearing puller, and a press, you would be best advised to take the spindle off, and take it to a machine shop. If you do not have the proper tools, you may damage the hub. very expensive part to replace.
SOURCE: replacing front struts on a 2007 toyota tacoma
REALLY HARD PROJECT, TAKE IT TO SEARS, IT WILL ALSO NEED FRONT ALLIGNMENT
SOURCE: how do you replace a right front wheel bearing on
remove the tire
Remove the caliper- two bolts in back, could be torx or allen
remove the bracket that holds the caliper- two bolts in back
remove the rotor, with hammer if nessissary
remove the big nut holding the shaft in the middle of bearing
there are three or four bolts that are in back that hold the bearing on the spindle remove these
use a screw driver and chisel to pry the bearing out of the spindle, you will have too beat on them so use an old screw driver. If the new bearing comes with the hub, then you can beat on the hub and knock it out. be careful because your limited on space and it is easy to hit something that you don't want to hit. If the new bearing doesn't come with the hub, you will have to have it pressed out and in. about twenty bucks at a garage.
Good luck
Randy
175 views
Usually answered in minutes!
×