SOURCE: i,ve got a problem
try pushing the clutch to the floor with you toes if it starts and won't unless you push to the floor its the clutch start switch 22 bucks at auto zone i will be gettng help installing the new one i will let you know.
SOURCE: change brakes on a 05 hyundai tucson
rear pad replacement is basically the same as front. 14mm bolts holding caliper and mount on hub then the piston just pushes in
SOURCE: Topping up gearbox oil on 99 Hyundai Lantra (manual)
You can actually do it from the top if it is similar to a 2001 Elantra??? On your right center of the tranny, there should be two big bolts I believe a 17mm one on the bottom left the other top right of the other. The bottom left is the drain plug the top right is where you fill it. If you want to make things easier you can remove the air cleaner and the air cleaner housing then unscrew the sensor on top of the tranny you can poor it in from the top. You will need to then unscrew the fill hole (Top right bolt) Pour the lube in to the hole where you had taken out the sensor until it pours out of the fill hole. Sounds like more work but by doing this you will avoid making a mess trying to fit the squeeze bottle into the tiny hole. Hope this makes Sense????
SOURCE: torque wrench settings for 97 hyundai lantra 1.8
They use throw away bolts. One use only, so don't reuse your old ones. You will need new ones. The smaller bolts 1st torque setting 22Ft/Lbs and the larger 26ft/lbs, the 2nd torque setting 60 degrees both bolt sizes and the 60 degrees for the third.
SOURCE: change hyundai accent 2001 front brake pads
Once the car is jacked up, remove the front tires, then whith a 12 wrench key, remove the bolt that is located on the rear side of the caliper, not the one holding the brake fluid line buth the one right next to it. Pry the brake pad holder off and then remove the brake pads themselves. You will need to press the caliper's piston in, to be able to fit new brake pads since new pads will be thicker.
50 views
Usually answered in minutes!
×