Driver's mirror broke off by person (not car)who ran into car. Replaced at home with mirror 62740G off Amazon. Now the mirror fuse keeps blowing (even after new fuse) when anyone tries to use the power mirror buttons. Nothing else happens except a blown fuse.
SOURCE: E.E.C fuse keeps blowing in 1991 Ford Explorer
if you replaced fuel pump i would look at backward wiring when replaced and i would start at the source of work if your vehicle was working fine before replacement then 9 out of 10 it will be your fuel pump wireing
sometimes when putting wireing back together the connectors have the missing clip and in turn you can turn the wireing in both directions now where positive is touching the ground on both sides of connector kris kross problem check your work this is crucial use a test light to find the right wires where they go
SOURCE: fuse keeps blowing out.
I had the same problem with my 2000 Windstar. It ended up being a brake fluid leak around a sensor on the master cylinder. The sensor is a known issue and has been redesigned. The brake fluid dripped onto some elctrical connections causing fuses to blow. The sensor turns off the cruise control when the brakes are pressed. On some vehicles it was known to cause fires and Ford had to provide a recall. At the time my Windstar was not covered in the recall but it may be now.
SOURCE: 2000 Malibu keeps running hot.
You replaced the head gasket but did you get the head or heads checked for cracks or check the block for warpage?
SOURCE: jeep keeps blowing auto shutdown fuse
Yes I had the same problem. The wires that plug into the sensor at the catatytic converter were rubbing against the drive shaft untill they finally wore through causing the short against drive shaft. repaired wires and it fixed everything
SOURCE: 98 stratus won't start
Sis had a 1997 Dodge Stratus and experienced issues with the cigarette lighter. Car would not start and I was able to trace an ignition fuse as the problem. Replaced the fuse and the car would attempt to crank but not start and the fuse would burn. Repaired the cigarette lighter and changed the ignition fuse but fuse continued to burnout. Pulled the accessory fuse and car attempted to start without the ignition fuse blowing. Put the accessory fuse back in place and the car started up no problem,
305 views
Usually answered in minutes!
×