Did the LT1 go in buick roadmaster

1 Answer

Matthew Swenson

Contributor 1 Answer
Posted on Jan 04, 2016

Matthew Swenson

Contributor

Joined: Apr 15, 2010

Answers

Questions

Helped

125

Points

Yes it did. I believe from 1995 up.

3 Related Answers

Bruce Bracey

1000 Answers
Posted on Apr 08, 2009

SOURCE: backfiring

The backfiring on deceleration is typically associated with a loose timing chain.

If you put a wrench on the harmonic balancer bolt, turn the balancer gently until you feel the chain tighten, then rotate the opposite way until it tightens, how far does is move.
If it goes more than an inch, it is getting sloppy. If it moves closer to 2 inches, it is worn out.
Try that first then let me know and we can go from there.
Good luck.
Regards,

Anonymous

118 Answers
Posted on Jan 26, 2011

SOURCE: what do you set the

350 chevy engines,running ,bac off untill clicking is heard then tighten until just silent,then one
half turn more

Anonymous

747 Answers
Posted on Sep 17, 2012

SOURCE: 95 buick roadmaster lt1 starts up when cold after it warms up it shut off then service soon light comes on i changed plugs new ignition control module new fuel pump new tem coolin senser still the sa

Have you had the code or codes read it could be anything from plugged injectors the code-s will let you know

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

Were do i spray starter fluid to get my 1994 buick roadmaster started Lt1 motor

Into the throttle plate , Look at round black rubber tube from air filter box over to the engine ! Use a screw driver , loosen the clamp and pull the hose off the engine , where it fastens is call throttle body . Look inside you'll see a round disk or plate what ever you want to call it . Have someone step on the gas pedal and hold it down , you will see the plate open . This is where you spary the starter fluid ! After spraying some fluid in have the person holding the gas pedal down , release it . Then try to start the vehicle .

Read full answer

Dec 10, 2016 • 1994 Buick Roadmaster

0answers

Where is the temperature control sensor located on a 95 buick roadmaster 5.7 LT1 engine

Read full answer

Be the first to answer Feb 10, 2016 • Buick Cars & Trucks

0helpful

1answer

Spark plug gap settings chart

You should be using platinum or iridium plugs with the LT1, and you don't gap those, they are set at the factory. If for some reason you want to use copper, it's .050", but they are going to wear out faster so you aren't saving any money by using them. Also, it's not a very easy job, so you wouldn't want to have to do it two or three times when you could have done it once.

Read full answer

Aug 01, 2014 • 1994 Buick Roadmaster

0helpful

1answer

95 buick roadmaster lt1 starts up when cold after it warms up it shut off then service soon light comes on i changed plugs new ignition control module new fuel pump new tem coolin senser still the sa

Have you had the code or codes read it could be anything from plugged injectors the code-s will let you know

Read full answer

Sep 17, 2012 • Buick Cars & Trucks

0helpful

1answer

Change water pump

If you click the link you can watch a video of the job on a 96 Impala which uses the same engine as your Buick that being the Chevy LT1 5.7L Corvette V8.