Both rear windows work fine from individual switches and drivers side. Both front windows stopped working. Individual switch on passenger side is not working as well.
Its usely the switches on the drivers door get a switch bundle from the auto wreckers .i dont deal with this enough to know why when the drivers switch wears out it affects both front windows .very common on chevy canyons. < japanease switches. new switches are insanely priced thats why suggest a auto wrecker switch bundle.
SOURCE: can't control passenger window in mazda 6
Passenger window lost programing. To reprogram, turn the key on, go to the passenger side and with the passemger switch run the window all the way down and hold switch in down position for 2 seconds, then run all the way up and hold in up position for 2 seconds, then repeat again within 5 seconds. Should work from drivers side master switch now.
SOURCE: No spark in '05 Mazda 6
any wires not plugged into there respective places, any sensors the old engine had that this one don't, did you use the old distributor for your coil setup,I think it might be, luck
SOURCE: Passenger window won't work using the driver side control switch
Open the window with the local button and keep the button pressed for 3 seconds after it has fully opened. Then close the window and keep the button pressed for 3 seconds after it has fully closed. This calibrates the position of the window which it lost when you changed the battery. Good luck
501 views
Usually answered in minutes!
Switches are auto driver side won't work or passenger. Passenger side worked when I replaced master switch but now it doesn't auto never worked on driver side but did on passenger. All the windows work with the individual switch and master but the pass front. Passenger front works using switch but not from the master
×