SOURCE: clutch pedal real soft
You could have either a failing master or slave cylinder or the hydraulic fluid level is very low which could also be from a leaking master or slave cylinder; check for wet-looking areas around both.
The master is located either inside or under the hood on the firewall; the slave is located on the transmission housing itself.
Until you locate the problem, use neutral gear position when starting so the tranny doesn't drag and load the starter.
After replacing the defective cylinder, be sure to bleed the lines (like when doing brake repairs) to avoid having an ineffective or just spongy pedal again.
SOURCE: Clutch Pedal Very Soft
Air in the system. The shave is between the engine and trans and even a small leak won't show up. Look in the rubber piece on trans with a light and see if you see any fluid. If you see any then the slave is starting to fail.
SOURCE: how to remove door panel on x90
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: Soft clutch pedal
well depends on how much milage on the clutch..I would start with clutch master and slave see if that helps because u have to replace any how.....good luck
60 views
Usually answered in minutes!
×