Not true. disconnect battery, turn key to run position then reconnect the battery, get in van and start. this will reset your anti-theft device
Have no idea aobut the needed recode, but if pinned dowen I would say maybe he is right. the cost in the USA is about $100.00
SOURCE: Recoding "spare" key for car after ignition cylinder was replaced
Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing working key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
SOURCE: VW Sharan (2000model) - Recoding Keys
Programming
When
Key buttons operated repeatedly while vehicle out of range and system becomes inoperative. Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Close all windows and doors. Insert key into driver's door lock. Turn key to unlock position 3 times. Remove key.
NOTE: Hold key in unlocked position for 0,5 second.
Programming mode activated (driver's door LED illuminated). Carry out the following within 20 seconds: Point key at infrared receiver. Located near rear view mirror. Press and hold lock button within 5 seconds Fig. 1 [1]. Press unlock button 3 times Fig. 1 [2]. Release lock button Fig. 1 [1]. Correct programming indicated by driver's door LED flashing. Repeat above procedure within 15 seconds to program remaining keys. To exit programming mode and extinguish LED: Wait 15 seconds.
NOTE: A maximum of 4 keys can be programmed.
192 views
Usually answered in minutes!
×