SOURCE: bleeding hydraulic clutch
well you will need some help
make sure the resivor is full and have someone hold the clutch pedal to the floor and crack the bleeder on the slave cyl. and close after the spert of fluid comes out. when the screw is closed have the person in the drivers seat slowly let up and push down 3 times and hold down and bleed one more time. refill your resivor and repete if you dont think the peddal is quite right. just dont run it out of fluid
good luck it realy isnt that hard.
later paul
SOURCE: Hydraulic clutch problems
i have a ktm 125 wich all ktms have hydraulic cluthcs and i have the same problem as all these fellas even when im riding it just sucks right down all the fluid reply to me on [email protected] ok thanks fellas
SOURCE: 1993 chevy silverado 4x4 4.3 4sp. clutch issue
somthing is leaaking down then from what your desribing. probably the slave is it leaking fluid into the bellhousing?? these do trap air badly too because the bleeder is on the rear of the slave and it runs down hill with the drive train. jack the rear of truck as high as possible to get the air to rise to bleeder and bleed again
SOURCE: hydraulic clutch 1995 chevy 1500 truck
I know you dont want to hear this but it sounds like the clutch plate is in backwards.
SOURCE: i bleed clutch hydraulic system
While you were bleeding the clutch, did you maintain the the hydraulic fluid level? It sounds like it ran out of fluid.
419 views
Usually answered in minutes!
×