Installation guide to install airbag honda accord 1995

This states is doesn't have an 'illumination wire', but has a 'stereo dimmer' wire.

95/96 Honda Accord Car Stereo Wiring Diagram ' Facebook

https://www.facebook.com > northern-primitive-accord
1996 Honda Accord Car Stereo Wiring Diagram Car Radio Battery Constant 12v+ Wire: Yellow/White Car Radio ... Car Audio Rear Speakers Location: Rear Deck

1995 Honda Accord Car Radio Wiring Diagram - MODIFIEDLIFE

https://www.modifiedlife.com > 1995-honda-accord-car...
How I find a 1995 Honda Accord car stereo wiring diagram? Whether you're an expert Honda Accord mobile electronics installer, Honda Accord fanatic, or a novice ...

USA Car?
stock 1995 accord IMMO? no here, till 1996.
USA car? dealer installed, aftermarket?
did your read the opr guide yet>?
here it is.
http://justgivemethedamnmanual.com/honda/honda-accord-coupe-owners-manuals/
oops...
there IS NO IMMO.
unless you or someone added it.

1996 is first year, for IMMO,

or if IMMO
try both FOBS. lost yours?

i did searched and , your system is very very rare.
good luck finding info on this system.

Is the noise comming from the passanger side floor?
Its Probably the blower motor, Could be around $350 for replacment and labor.

driver side, under dash, above fuse box mounted on kick panel

Wash the engine if need be to find the source of the leak.  It could be the oil fill cap, the valve cover gasket, the oil filter seal or a dozen other places.   

When an SRS cable reel assembly is removed and set aside during vehicle repairs, the cable reel may rotate inside the assembly so it is no longer centered. If the assembly is reinstalled with the reel off-center, the cable can break when the steering wheel is turned to full lock. The cable reel holding fixture locks the reel while the assembly is off the vehicle, keeping it centered for reinstallation.
CABLE REEL REMOVAL PROCEDURE
1. Follow the procedure in the appropriate service manual for disconnecting the battery, and removing the dashboard panels, steering column covers, airbag, and steering wheel.
^ Always install short connectors on the connectors for the driver's and passenger's (if so equipped) airbags.
^ Make sure the front wheels are pointed straight ahead before removing the steering wheel.
2. Verify that the cable reel is centered; the yellow gear tooth is lined up with the alignment mark on the cover. Install the cable reel holding fixture in the cable reel assembly as shown. Use a TORX T-10 wrench.
3. Disconnect the 6-P connector, then remove the cable reel assembly.
CABLE REEL INSTALLATION PROCEDURE
1. Verify that the front wheels are still pointed straight ahead.
2. Reinstall the cable reel assembly, and reconnect the 6-P connector.
3. Remove the cable reel holding fixture.
4. Follow the service manual procedure for reinstallation of the steering wheel, airbag, steering column covers, and dashboard covers.
5. Verify SRS operation as described in the service manual. Road test the vehicle.
^ If the steering wheel spoke angle is not correct, change it by adjusting the tie rod ends. Do not remove and reposition the steering wheel.
PARTS INFORMATION
Cable reel holding fixture:
For 1992-95 Civic and Ohio-produced 1992-95 Accord
P/N 77900-SPO-999, H/C 4733564
For 1991 Accord Wagon, 1992-95
Prelude, 1995 Odyssey and Japan-produced
1992-95 Accord
P/N 77900-SM5-999, H/C 4733572
WARRANTY CLAIM INFORMATION
Use the Flat Rate Manual information for the repair being performed.

he could have tapped into the power line for the airbag system or loosened the wire during the installation. if you went to a professional, take it back to him/her. but, on the off chance that it is a cowinkidink have it checked by someone that can access the airbag system. body shops are good for that purpose because they see that type of work from accident cases.

timing...might be seized already because it is a zero tolerance motor