1999 Chevrolet Silverado 1500 Logo

Related Topics:

A
Anonymous Posted on Nov 29, 2013

Replace leaking fuel line on 2000 chevy silverado 1500

There is a leak in the fuel line below the drivers side of the truck (one at the bend and one, at what appears to be the connection)

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Feb 01, 2009

SOURCE: 2000 chevy silverado 1500 4.3 eng

Chevy Trucks, Blazers, S10 pickup and the like will vapor lock ecspecially the 2000 models. Do not tighten the gas cap past 1 click. There is a tube that runs from the top of the tank down and this gets hot and collapses or burns in half. We just bought a reinforced rubber tube cut it to lengh and use it instead of part and it's worked grat for 2 years so far.

Ad

Anonymous

  • 149 Answers
  • Posted on Mar 13, 2009

SOURCE: 2000 Chevy Silverado 1500 Replace the fuel pump - ?

First check the fuel pump fuse in the fuse panel to make sure its not blown. Chances are that it is the fuel pump, that is a common problem with chevy trucks. The easiest way to access the fuel pump is to remove the bed of the truck from the frame. Good luck. dont forget to rate.

Anonymous

  • 27 Answers
  • Posted on Aug 07, 2009

SOURCE: process to change fuel pump on 2001 chevy silverado 1500

take the six bed bolt loose and then take three buddies slide the bed back put in the new pump slide it back n place and put the bed bolts back in. if u drop the tank u can easily break the hard plastis lines that go to the fuel tank. u only have to take the fill lines and taillight wires loose this way its alot quicker, and easier.

Anonymous

  • 1 Answer
  • Posted on Oct 07, 2009

SOURCE: 2003 chevy silverado 1500 check engine light on

2003 chevy silverado
A picture of a engine is on the dashbroad, what can I do to get it off.
Rita

john h

  • 29494 Answers
  • Posted on Oct 24, 2009

SOURCE: My 1999 chevy tahoe is leaking antifreeze. I

it could but- check passenger side front where heater core line go into manifold right behind alternator the hose line is connected by a press clip into an alloy fitting this fitting gets eaten away by anti freeze and hose angle pulls back on fitting the part is $18 at dealer and is screwed into manifold use caution if ur r going to replace at very edge of aluminum manifold---and check ur water pump bolts the 2 longer ones should have a lock sealant on them they bolt in thru a water jacket

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2000 silverado problems

Common problem on that model chevy. Check the fuel regulator to make sure is not leaking. Allow it to run for a few minutes and shut it off then pull the vacuum line off of it. If there is fuel in there that it is leaking. If that checks out it will most likely be the fuel pump. If you cycle the key a few time then it starts fine it will be the pump
0helpful
2answers

2002 chevy silverado i have 3 codes. P0137, P0160, P0300

mean you replace front O2,codes mean back O2 sensor,spark plugs,fuel filter,could be battery[300].
1helpful
1answer
0helpful
2answers

Water leak on the back side of my motor

could be heater hoses, intake gasket, head gasket
2helpful
2answers

Fuel filter

It should be located just ahead of the fuel tank, mounted on the frame rail.
Good luck.
Regards,
2helpful
2answers

2000 Chevy Silverado Z71 hard to start

Pull the vac line off the regulator right after you stop the engine. See if there is gas in the vac line if so the regulator is bad. If no gas is present it could be the check valve in the fuel pump letting the gas pressure leak down. Get a set of gauges and hook up to the fuel lines and check for pressure loss. You will have some loss but should hold steady for several hours. Another thing to try is turn the key on and off several times before trying to start this will charge the lines if this works every time you are losing fuel pressure. If you still have trouble when doing this I would look somewhere else besides the fuel system
6helpful
1answer

1996 Chevy Silverado 1500 Starting Problems

Just from what you said it sounds like your vehicle might not be holding its residual pressure which means after you turn a vehicle off, your fuel injection system should hold a certain amount of pressure in the system, but if that pressure drops to fast your vehicle may have a hard time starting. Things to look for when you lose fuel pressure is the fuel pressure regulator may be leaking, fuel pump check valve,leaky fuel injector or they maybe a small leak in one of the fuel lines. I only suggested this cause i had a car with the similar problem.
Not finding what you are looking for?

402 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...