No running lights when head lights are on with new switch
SOURCE: rear axle seal replacement 1994 ford bronco
It is fairly easy to do. remove rear wheels and brake drums, remove the differential cover, rotate the diff to access the diff pin bolt and remove, remove pin, push axles inward and remove c clips, slide out axles and replace seals. reverse procedure
SOURCE: remove dashboard on a 88 ford bronco 2
You don't need to remove the dash. Look under the dash where the switch is located. on the side of the switch you will see a small button to push in. While pushing in on the button pull the knob as though you were going to turn the lights on. At this time the stem should release from the switch. Undo the bezel and drop the switch down so you can see to unplug the wires. Replace wires to new switch and reverse the procedure to install. You don't need to push the button in when replacing the stem.
SOURCE: 1994 Ford Bronco SRS light flashes 32 code.
Probably code 32 which has to do with the egr system. Check you vacuum lines.
SOURCE: 97 Ford E250 Running lights and dash lights not working
best bet is get a WIRING DIAGRAM. you should have current (12 volts) on both sides of the fuse that works the tailights.if not there is probably a broken wire or a shorted wire leading up to the fuse. you kinda need the wiring diagram so u can see in which order the current "flows" which will help point u in the right direction.
SOURCE: ford f250 running lights, dash lights and parking lights stay on
Had the same problem and it was a short in the trailer light hook-up.
247 views
Usually answered in minutes!
×