2001 tiburon none of my lights work besides my low/high beams and turn signals i changed the headlight switch and still nothing bulbs are good fuses are good every it the box under the hood is good

Check the fuses first. then replace the turn signal switch if all fuses are good. All the lights run threw it, except the high brake light on the rear.

Button floor click or pull turn signal towards you easily
relay is on

there is no fuse for high bean light. the same light bulb that does your low beam, will also do high beam. Now because your signal lights are not working,it could be the multi-function switch. Any repair shop will quickly diagnose this problem. If you know how to change the headlight bulb of your car, i would start with that.

The headlight switch gets power for the headlights from a 50amp fuse.
The fuse powers the headlight switch then the dimmer switch breaks for high and low beams. So if the high beams work, the problem may be with the dimmer switch.
The dimmer switch is made into the turn signal switch on the column. You would need to check the low and high beam circuits at the switch for power.

These trucks are known for bad multifuction switches.
the switch that i talk of is the signal switch , the handle is the switch, it bolts to side of steering column . this switch controls the signals and the headlights and high /low beams. the other thing is the headlight switch connector, the connector some times goes bad and starts to melt or just comes out of the connector. you will need to remove the cover to steering column, the screws are located under the bottom cover in holes. remove cover and check connector and then test for power if you have power going into switch but not coming out then switch is bad.

the last thing is to make sure the bulbs are good , make sure the headlight bulbs are good , and also the driving light bulbs, test for power at the connectors to those lights to.
You will need to do a little testing to find the problem.

Bad dimmer switch, or headlight switch.

Both sides or just one? If both, The multi-function switch on the steering column is not working properly

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

I have a 2004 ram 2500 and all my lights work except for low beams. It is not in the switch, I haver replaced the switch with no change. This is a circuit problem with these dodge pickups. I haven't firgured out what it is but it isn't the switch. and unless the low beams and high beams are fused seperate, it isn't a fuse problem either. i have looked for a fuse and can't even find the fuse for the headlights. Im lost like you!

faulty light switch or light control module