Warning light came on. Local garage drained fuel filter, but did not have equipment to reset light
SOURCE: reset warning engine light
you can reset the engine warning light by taking the earth lead off the battery and connecting it to the positive lead, then switch on the ignition,. Reconnect the earth lead to the battery and the light will have been reset. What you are doing is discharging the diagnostic chip to earth, which is exactly what the jaguar main dealer equipment does.This works on all cars.
PLEASE NOTE, make sure you disconnect the earth lead from the battery .
SOURCE: low level coolant warning light stays on but water
Hi:
It is common for the sensor to fail on these. It is part of the coolant tank cap assembly.
SOURCE: abs warning light on traction control fault
Check for short in the electrical system as that is what is causing the Drain , then check if the Generator is working properly
SOURCE: my coolant warning light stays on the dash, after
You can force the vehicle into a full reset by disconnecting the battery, but beware that you may need your radio code re entered after this. The vehicle will then go into drive cycles to reset the computer. If the light re- illuminates then you have other problems.
SOURCE: No audible warning when exceeding local speed limits
look on your screens, i think it is on screen 3 there is a picture of a speaker if it's got a X on it, touch it the cross should go out, it is to mute the speaker.
4,181 views
Usually answered in minutes!
Thanks Graham, that fixed the problem.
×