Brakes goes to the floor, brake fluid has leaked out. Have no brakes
Catastrophic failure , DO NOT DRIVE
so find leak, see leak location, that is BAD.
MC (master cylinder)
or slaves (calipers or drum cylinders.
or hoses. (any)
pipes, (aka, hard lines)
junctions.
aBS?
why not post source of leak, or better photos.
or better yet, call a mech. for help .
floor, floor of cab, floor of garage, just a tiny hint on floor
and what 4 corners of car. inside or outside.
,fluid can leak down both sides of any MC
SOURCE: toyoyta mr2 brakes are gone
What part is bad that is leaking? Sounds like you are getting air into the brake line and this will cause a problem with te pedal going to the floor
SOURCE: my brakes are spongy and i need to check brake fluid where is the brake fluid?
Bleed the system to flush out air bubbles.
SOURCE: brake pedal goes to floor
YOU NEED TO OPEN THE BLEEDER BOLTS AND LET THE AIR OUT OF THE BRAKE SYSTEM .
SOURCE: Brake pedal is sometimes sinking to floor. Brake
most likely your master cylinder is acting up try to press hard on your break for a period of time and see if the pedal will sink/replace master
SOURCE: 91 Toyota 4Runner.Little to no brakes. I have
You may have a bubble in the ABS. You can try bleeding there by loosening the lines one at a time, like bleeders. I have read that you might need a special rig to bleed some ABS systems. :-(
163 views
Usually answered in minutes!
×