Wiper pump wont work. Already changed pump for new one and checked # 3,6,14 fuses, all good, is there a relay as well?
Washer pump dead.
never checked for 12v at pump turned on? (2 man)???????
if 12v there, the fuses are and all is working, easy 5min test.
i can see you didnt test the pump, for power.
pump tests (try with no hydraulic load first)
you removed the pump clean it , connect only the wires,
turn it on , does it spin? buzzzzzzzzz, (simple , no ?) it buzzes.
put it back and no hose connected. does it pump water>?
at its output port (open to the world) no hydraulic load)?/?
yes, then it's good. easy huh? and new pump now, so is.... and was....
conclusion here is the head, or load, is packed up.
not free flowing. # 1 cause, of all bad washers. is this...
for mixing wrong cleaners or other bad things in the tank.
solution:
then clean the hoses and nozzles, and some have an inline
check valve, that clogs.
packed or pinched lines
packed check valves.
packed nozzels
SOURCE: 05 Jeep Wrangler High Beams Work, Low Beams dont
There are no relays for the headlights. Your problem could be from the headlight switch. You would have to check and see if you have power coming out of the switch on the low beam side. Check with a test light.
SOURCE: Jeep wrangler Fuse box
You have two locations for the fuse box. One is either under the hood or behind the glove box. I would pull apart the glove box and take a look.
SOURCE: 1998 Jeep Wrangler Electrical Short in Steering Column?
I had a similar problem with my 2000 Jeep TJ and I found the problem in the wiring harness under the hood.several wires were corroded and almost burnt off.If you remove the black tape which keeps the harness bundled together and if you see evidence of "green" type powder or "gook" it's most likely where the wires have faulted.
SOURCE: 2000 jeep wrangler just shut off changed fuel pump
check foe fuel pump presure at fuel rail,,,if u have fuel pump presure check all fuses with a test light not buy sight,,could be deceviving ,look at and check to see if fuel pump relay is working if no fuel presure i,if u have presure in fuel rail ,replace the cranck shaft sensor
SOURCE: Jeep Liberty 2005 Rear Wiper Not working. Change
could be the arms striped ore the motor shot on it
285 views
Usually answered in minutes!
×