Does it has 2 tension pulleys
SOURCE: Loud squealing sound in my engine
hey
Its possibly the belt!!! did you change that to?
Damien
SOURCE: 1997 Jeep wrangler
Clock spring mech is prob bad, first easy check is remove airbag 2 8mm bolt from back side of wheel make sure wires are still connected if they are good the clock spring mech is bad you can use a steering wheel puller to remove wheel and clock spring mech just snaps out and has 2 plugs on it, I have 2 if you need one.
SOURCE: Loud squealing sound in my engine
Try removing the belt and turning each pulley by hand. If everything is smooth and free, with the belt still off, drive down the block once and see if the noise is there (this will eliminate all rotating accessories on the front). If you hear the noise, then there is a problem deeper inside. Oil pressure is good? Dont' forget when doing this, you will have no power steering, so be careful.
SOURCE: Jeep 1997 Wrangler. Gear shifting very hard
synchronizers are going bad a used trans would be cheaper than a rebuild due to the labor involved
SOURCE: engine diagram 1997 jeep wrangler SE
So how do you know you need one if you dont know where it is?? Oil pumps rarely go bad unless the engine is sludged from lack of maintenence. After you take the oil pan off, its there hanging down. Make sure you clean or replace the pick up tube. I'm sure you can google up torque specs, for the bolts. Usually there is major engine damage by the time you figure out that there is lack of oil pressure. I would get a professionals opinion before you waste time and money replaicing the oil pump. If the engine has any unusual noise or knocking, its too late.
129 views
Usually answered in minutes!
×