Question about Cars & Trucks

1 Answer

Horn goes off by itself, need to know which fuse if for the horn on a 2008 chrysler sebring convertible

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,615 Answers

You can see if you have a blown fuse in seconds using my method!
Don't waste time searching for the exact location, just check them
all. You can find it by pulling out each fuse one by one. Don't mix
them up, replace each one as you go, make sure to look at each
one. You may even find you have more than one bown fuse! If you have some needle-nose pliers, they work very well, most times you can use your fingers. Here are a few pictures if your unfamiliar with what your looking for:
horn goes off by itself, need to know which fuse i - 89edae19-7a24-41d9-bb8d-c26dbc148cb4.jpg

Posted on Dec 19, 2013

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 137 Answers

SOURCE: Horn won't turn off

remove the horn relay its in the power distribution box...

Posted on Jan 28, 2009

Anonymous

  • 1 Answer

SOURCE: Lowering convertible top

You have to pull down the visors and release the top handles to free the top. Hit the button enough to raise the top slightly and put the handles back in the closed position. Then you can put the top all the way down. There is a built in safety feature, where the window go down slightly as the top starts to open.

Posted on Apr 07, 2009

Anonymous

  • 2 Answers

SOURCE: replace air filter 2002 Chrysler Sebring convertible

you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.

Posted on Apr 28, 2009

Anonymous

  • 88 Answers

SOURCE: CHRYSLER SEBRING - WHICH FUSES GO TO/AFFECT WHAT PARTS OF CAR

the diaghram for the fuses will be on the back of the fusebox lid that you have removed and will tell you which fuse is for what

Posted on May 20, 2009

Anonymous

  • 47 Answers

SOURCE: The horn on my 2006 sebring is going out. Is this a major fix?

It is located behind the right headlight assembly, remove that, one mounting bolt, and wiring harness, and it's out.
If you need anything else, let me know.

Posted on Mar 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Sebring convertible horn won't work is there a fuse for this?


disconnect the battery and check the wires that connect the horns. If corroded, clean them up with crocos cloth. Connect the battery back up and try again. If they don;t work, disconnect one horn at the terminals and set the multimeter to VDC on the lowest setting and have someone press the horn. If the needle deflects, they your horn driver is (speaker) blown and you'll need to find replacements. There are usually two horns; one high octave and one low. Some cars have a fuse for the horns. Even if it looks good, replace it as it sometimes hard to tell.

Aug 12, 2017 | Chrysler Sebring Cars & Trucks

1 Answer

Sebring horn


Do I need to remove the front number to get to the horn. Chrysler Sebring convertible. 2008

Jan 10, 2014 | 2004 Chrysler Sebring

1 Answer

Where is the horn fuse


It should be under the dash on left side kick panel.

Dec 19, 2013 | Chrysler Cars & Trucks

1 Answer

Horn goes off by itself


horn relay, or horn button faulty.

Dec 19, 2013 | Chrysler Cars & Trucks

1 Answer

What do i do if my horn does not work in my 2006 sebring convertable


check horn fuse and relay.if both good hot wire horn if it works the horn button pad need replacing meaning you have to replace the whole horn pad and airbag in the steering wheel.if horn dont work when hot wired more likely horn is bad.

Apr 17, 2013 | 2006 Chrysler Sebring

1 Answer

I have developed a short in the horn on my 2005 Chrysler Sebring convertible. I would like to disconnect it but can't find it under the hood. Do you know where it is located? Do you know a safe way for me...


You can do one of two things. Remove the fuse to the horn, if it has it's own fuse, or under the bumper in the front, you will find two horns (a high tone and a low tone), that has a Green wire with a Red tracer on it. Wiring colors on Chrysler's haven't changed much since 1960. A Haynes Manual for your vehicle is of utmost importance in working on your own vehicle now a days. The Haynes Manual you need is a #25040 available at most part stores. (so you can call around to see if they have it in stock). In the back, it has wiring diagrams as well to help you chase wires throughout your car as well as any major or minor repair...along with pictures provided throughout the book.

I hope this helps you,

"00 Buck"

Jul 18, 2010 | 2005 Chrysler Sebring Conv

1 Answer

2005 sebring convertible- horn goes off by itself for 30 seconds


FIrst off the horn's ground works through the steering wheel,so the wire is bare or the end is broken and grounding in a place where it should not. You will have to check the wires for the horn from the fuse box up to the wheel.
your power feed to the headlights and the door locks has an open ( the power is not connected somewhere ) Perform a wiggle test turn on the headlights and lift the hood,find the power distribution box and begin to wiggle the wire harness.Sometimes the chrysler fuse box under the hood get loose inside the power distribution box,it will have to be broken down all the way to the heavy wires comming out of hte box,you can tighten these connections your self.

Aug 08, 2009 | 2006 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...