Question about Chrysler Cars & Trucks

1 Answer

Horn goes off by itself

2008 sebring convertible

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 1,615 Answers

Horn relay, or horn button faulty.

Posted on Dec 19, 2013

Ad

4 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

patrick_j950

  • 31 Answers

SOURCE: how do i change the digital clock on the 2008 sebring?

there should be a "H" and a "M" on the console with a small hole beside it,use a pen to push the recessed buttons

Posted on May 06, 2009

Anonymous

  • 490 Answers

SOURCE: 2005 sebring convertible- horn goes off by itself for 30 seconds

FIrst off the horn's ground works through the steering wheel,so the wire is bare or the end is broken and grounding in a place where it should not. You will have to check the wires for the horn from the fuse box up to the wheel.
your power feed to the headlights and the door locks has an open ( the power is not connected somewhere ) Perform a wiggle test turn on the headlights and lift the hood,find the power distribution box and begin to wiggle the wire harness.Sometimes the chrysler fuse box under the hood get loose inside the power distribution box,it will have to be broken down all the way to the heavy wires comming out of hte box,you can tighten these connections your self.

Posted on Aug 08, 2009

cheung232

cheung232

  • 10 Answers

SOURCE: navigation system freezes and closes

It is because you are giving it commands to fast, try to be a little more patient.

Posted on Aug 22, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Sebring convertible horn won't work is there a fuse for this?


disconnect the battery and check the wires that connect the horns. If corroded, clean them up with crocos cloth. Connect the battery back up and try again. If they don;t work, disconnect one horn at the terminals and set the multimeter to VDC on the lowest setting and have someone press the horn. If the needle deflects, they your horn driver is (speaker) blown and you'll need to find replacements. There are usually two horns; one high octave and one low. Some cars have a fuse for the horns. Even if it looks good, replace it as it sometimes hard to tell.

Aug 12, 2017 | Chrysler Sebring Cars & Trucks

1 Answer

Horn goes off by itself when cold in my chrysler sebring touring


Could be the horn relay or the pad on the steering wheel.

Jan 23, 2014 | Cars & Trucks

1 Answer

Sebring horn


Do I need to remove the front number to get to the horn. Chrysler Sebring convertible. 2008

Jan 10, 2014 | 2004 Chrysler Sebring

1 Answer

Where is the horn fuse


It should be under the dash on left side kick panel.

Dec 19, 2013 | Chrysler Cars & Trucks

1 Answer

Horn goes off by itself, need to know which fuse if for the horn on a 2008 chrysler sebring convertible


You can see if you have a blown fuse in seconds using my method!
Don't waste time searching for the exact location, just check them
all. You can find it by pulling out each fuse one by one. Don't mix
them up, replace each one as you go, make sure to look at each
one. You may even find you have more than one bown fuse! If you have some needle-nose pliers, they work very well, most times you can use your fingers. Here are a few pictures if your unfamiliar with what your looking for:
89edae19-7a24-41d9-bb8d-c26dbc148cb4.jpg

Dec 19, 2013 | Cars & Trucks

1 Answer

What do i do if my horn does not work in my 2006 sebring convertable


check horn fuse and relay.if both good hot wire horn if it works the horn button pad need replacing meaning you have to replace the whole horn pad and airbag in the steering wheel.if horn dont work when hot wired more likely horn is bad.

Apr 17, 2013 | 2006 Chrysler Sebring

1 Answer

Navigation system freezes and closes


It is because you are giving it commands to fast, try to be a little more patient.

Aug 22, 2012 | 2008 Chrysler Sebring

1 Answer

2005 sebring convertible- horn goes off by itself for 30 seconds


FIrst off the horn's ground works through the steering wheel,so the wire is bare or the end is broken and grounding in a place where it should not. You will have to check the wires for the horn from the fuse box up to the wheel.
your power feed to the headlights and the door locks has an open ( the power is not connected somewhere ) Perform a wiggle test turn on the headlights and lift the hood,find the power distribution box and begin to wiggle the wire harness.Sometimes the chrysler fuse box under the hood get loose inside the power distribution box,it will have to be broken down all the way to the heavy wires comming out of hte box,you can tighten these connections your self.

Aug 08, 2009 | 2006 Chrysler Sebring

1 Answer

Horn won't turn off


remove the horn relay its in the power distribution box...

Jan 20, 2009 | 2005 Chrysler Sebring Conv

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...