My windshield wiper motor works, but washer does not work/

There is a electric motor that pumps washer fluid . Located in the bottom of the washer fluid tank .
Wash Operation (Front and Rear Wipers)
The front and rear washer systems use the same windshield washer fluid pump. When either the front or rear wiper is in the washer position voltage will be supplied to one side of the windshield washer fluid pump (depending on whether it is front or rear), while the other side of the pump is grounded.
At this point, the windshield washer fluid pump sprays solvent onto the windshield. When the front or rear washer is activated, the BCM receives an input from the switch that is activated. The BCM will control the wipers while in the WASH mode. The BCM will control either the front wiper relay or the rear wiper relay to turn on the wipers. The windshield wipers operate at low speed for 3 swipes and returns to the park position.

When turning on the washers do you hear the motor run ? Have some one try it while you listen at the washer fluid tank ! These pump motors do go bad .
turn OFF the ignition.
Disconnect the harness electrical connector of the windshield washer fluid pump.
Connect a test lamp from the windshield washer pump control circuit to a good ground .
Turn ON the ignition, with the engine OFF.
Press the front washer switch.
Does the test lamp illuminate?
YES or NO !

Does the pump motor run when turn windshield spray?
Might be home in line.
Might be wrong fluid(too thick)
Might be wiper fluid motor broken.

1. check your windshield washer fluid level.
2. make sure you can hear the fluid pump operating when you operate the switch.
3. If you can hear the pump working and you have fluid in the reservoir but still no spray,
   
4. check the washer fluid lines don't have holes and aren't clogged or pinched. check the sprayer nozzles make sure they are not clogged with debris.
5. if your washer still doesn't work your fluid pump is probably the problem.
   

If the pump works, something should be flowing thru the hose to the spray nozzles.
And if the pump works, everything electrical is working.
How do you know the pump works ?

Is your wiper fluid level good?Look for leaks at pump,it's connected to container,also check your hoses leaving pump to windshield,could be loose or binding.

lil piece of dirt in the sprayer, might be able to take a needle and poke it some and get it un stopped..

CHECK WIPER FLUID LEVEL FIRST ALL IS GOOD CHECK FOR POWER AT WIPER WASHER PUMP MOTOR.IF NO POWER AT WIPER WASHER MOTOR.CHECK 15 AMP FUSE IN THE ENGINE COMPARTMENT FUSE RELAY BOX.IF YES YOU ARE GETTING POWER AT WIPER WASHER MOTOR.WIPER WASHER MOTOR FAULTY.

Most likely a bad washer fluid pump.

follow the windshield spray nasal water lie to the pump making sure the line is not broken, next do you hear the pump running when you spay the fluid, if not that the pump is faulty, if you do hear the pump running, more likely the windshield spray nasal is clog with debris; to unclog it try to use a clothes needle, poke around in it to see if you can clear the blockage, if not, replace will be the best idea, fairly cheap and easy to replace. those windshield tank and the pump does not have good filter on them and they tend to get clog up in the pump or the spray nasal.

The washer pump should be in the resivoir bottle...remove the plug on the bottom of the resivior and check it for power when the washer button ie pushed... if you have power, then you should replave the washer motor...
Please rate this,
Rob...