2005 Toyota Corrolla Reset Maint Req'd light

2006-2015 Toyota Highlander MAINT REQD Light Reset

seventrumpet.com/2006-2015-toyota-highlander-maint-reqd-light-reset/
Mar 15, 2015 - How to MAINT REQD Light Reset on Toyota Highlander 2006, 2007, ...Turn the ignition switch to the "On" position, but do not start the engine ... This procedure should applies to the second and third generation of the Toyota Highlander (2005, 2006, 2007, 2008, ... Your email address will not be published.

1) Turn your key to the on position (dash lights will come on)
2) Push the odometer button until the total miles are displayed and keep holding it.
3) Turn the key Off, and then back ON while holding the odometer button in.Don't let up on the button. You will notice the odometer reading shows dashes and they will sequence off. After they sequence off, the Maint Reqd light will go off. Release the odometer button

It's probably your regular scheduled maintenance (oil change) light. Here's how you can reset that:

1. Turn the key to "on" so the electrical system is fired up (but engine is not running)

2. Set trip planner to "A" trip.

3. Turn key off (no electrical)

4. Hold down trip button, then turn key to "on" so the electrical system is fired up (but engine is not running).

5. "Maint Req" light will blink several times and then go off.

Good luck!

Turn ignition to "ACC" and press the odometer button until the display reads actual mileage (not Trip A or B).
Turn ignition off.
Hold the same button down that you used in step 1.
While holding the button, turn ignition to 'ON'.
The 'Maint Reqd' light should blink and go out.
Done!

Hello, and welcome to FixYa.

The 'Maint Reqd' light indicates that you are due for an oil change. It will blink 4,500 miles since the light was reset at your last oil change, and stay on steady after 5,000 miles.

If you recently had an oil change, all you need to do is reset your maintenance reqd lamp. The procedure is here on this site inthe 'tips and tricks' section, and it is also in your owner's manual.

Reset the "MAINT REQD" Light on Toyota Sienna:

1. With the car started (ignition on), set the LCD odometer readout to total mileage (not trip A or B).
2. Turn the car off (ignition key to the OFF position).
3. Push in AND HOLD the button/knob that switches the odometer
4. Turn key to ON position without starting the car. You will notice the maintenance light blink and go out.
5. Release the odometer button/knob.
6. Turn key to OFF position.
7. That's it! The "MAINT REQD" light has been reset to warn you to change your oil in another 5,000 or 7,500 miles or so.

Hope helped with this (remember rated this help) Good luck.

To reset the system. Turn the ignition key to the "OFF" position with the odometer reading shown. Turn the ignition key to the "ON" position while holding down the trip meter reset knob. Hold down the knob for at least 5 seconds. The odometer indicates "000000" and the light goes off. If the system fails to reset, the light will continue flashing.

watch this free video instructions on how to reset your maint reqd light if video dosent work go to www.vehix411.com

you need to hold down the reset button with one hand while you turn the key on, you will see the 5 lines count down

That is for oil changes. It come on when the oil change is due.
When you have your oil change done, the lube tech should reset the this light every time.
If you need help resetting the light, let me know.