If the rover is running very well, but i drive over water the cold down a little and the problem start over
SOURCE: Starts fine when cold, after running dies on idle then wont start
Sounds like the fuel filter is dirty and needing to be changed. It's cheap and easy to swap out.
SOURCE: 1998 Land Rover Discovery Series 1
You can energise the interlock solenoid, by you give a positive (+12V) lead to the RED and a negative (ground) to the black line at the transmission selector's connector.
If it works you should check the positive signal at the red.
It should be there if the ignition is on, brake pedal depressed, and the transfer box is in some gear, and the fuse 1 isn't blown.
At the black cable should be a ground signal if the selector in 'P' position.
If you give me an e-mail address I'll send the wiring.
The ABS problem, you have better to check followings.
- All the wheels bearings' play.
- are the ABS sensors at the deepst position? Knock some to that head (not strong) and they shouldn't move deeper.
-land rover repair
SOURCE: my land rover discovery is stuck in 4 wheel drive,
The discovery is as previously mentioned permanent four wheel drive.However the difflock/range lever in most suffers from lack of use and siezes all i had to do when i bought mine was plenty of WD40 and patience as i don't think it had been in low range or difflock from the day it was built.don't try to force it just spray it and let it soak then try keep doing this and it should free up if not it may be the selector grubscrew has worked loose just threadlock it and screw it back in.
120 views
Usually answered in minutes!
×