Seating in the drivers seat , make sure all doors are closed.Insert key into ignition, don't turn on yet.
Wait for the dome light to go out, then press and hold the door unlock button , make sure it is UNLOCK, while turning the key ON OFF ON OFF Twice , do not engage the started, just on to the point of being on. Release the unlock button,and your doors should lock, then unlock indicating programming mode.At this point hold down both the lock and unlock button on the key fob. After 30 seconds your locks should lock and unlock, indicating the fob is programmed. This must be repeated for all remotes, whether or not it be new or old. After all remotes are programmed, turn the key off and on again to exit programming mode.
SOURCE: can't find button under dash to reset/reprogram keyless entry
my GPS in my legacy is not working . i have get tin it recalibrate it and it works for about 15 to 20 mints then it goes crazy again. at one point it showed the car driving in the water when i was on the 287 west. how do i fix this ?
SOURCE: Need firing order diagram for 2002 gmc envoy
one, five, three, six, two, four
The plastic intake should have this sequence molded into it somewhere, and even the corresponding cylinder numbers in front of their respective holes. Have fun, and thanks for posting on Fixya.com
SOURCE: nissan murano 2005 sl keyless entry remote programing
Close all vehicle doors, LOCK doors using drivers side switch.
Insert key all the way into the ignition, (do not turn) remove key.
Repeat this step 5 times. (6 total)
Hazards should flash to indicate program mode.
Press any button on transmitter to be programmed, hazards should flash to indicate successfull program.
*For additional remotes, cycle drivers door lock UNLOCK, LOCK, press
any button on remote, hazards should flash. Repeat step as necessary.
Ignition ON, (engine off) ignition OFF, UNLOCK using drivers side switch, test remotes.
Source
SOURCE: Remote Keyless Entry fob for my 2007 Suzuki XL7
Not 100% sure about Suzukis but on my ford the same happened to me and I had to program them at the same time. Hopefully this helps.
SOURCE: remote keyless entry not working
KEY FOBS FOR THIS MODEL MUST BE PROGRAMED USING A TECH 2 SCAN TOOL SO IT MUST BE DONE AT THE DEALERSHIP FOR ABOUT HALF HOUR LABOR HOPE THIS HELPS
1,684 views
Usually answered in minutes!
×