Ok I ran out of gas ,going north up a hill. went got gas put a gallon in the tank ,truck would not start,went got 4 more gallons still truck would not start. moved truck down the hill onto flat ground still truck would not start. let truck sit for three hrs truck starts but dies 3miles down the road. next morning a mechanic friend hooked it up to his computer , tried to start computer put out firring out of sequence code
Reset the computer & check the fuel PSI. You may want to replace the gas filter. when u run dry, the filter picks up all the dirt at the bottom of the tank. Make sure your gas PSI is good before u get into electronics. start w the basics. That would set that code too trying to start dry.Good luck
SOURCE: My 2003 Yukon will not
The pci 20 amp fuse (or pcim) I forget is what burned up when I ran out... Popped a ne won in after putting a gallons back into the tank and away I was off... Easy fix (it is the one above the (PRIME) print on the fuse board.
SOURCE: i need help resetting my 94 GMC seirra's gas gage
the gas gauge is on the fuel pump assembly with in the fuel tank, you must have bumped it during reassembly. the only solution is removal. pull it out check for alignment and binding, reassemble being very careful. hope this helps.
SOURCE: Engine sputtering now it wont start
sounds like the same problem i was just having try changing out your fuel regulator its pretty pricey try to find the cheapest around $75.
SOURCE: ran out of gas now won't start
Depress shrader valve on fuel rail and see if pump primed,If primed take air snorkle from throttle body of and use carb cleaner to gett running,Some one can keep giming short burst or cleaner to thottle boby inlet till air gets out of system.Have seen this before.Air trapped in injectors.
111 views
Usually answered in minutes!
×