Distributor wont spark

Change your ignition module. The distributor is a weak point of the Honda, I will always change out the whole thing than just try the coil.

check see if coil getting power.if no check ignition fuse if yes getting power at ignition coil.either ignition coil is bad or thick film module on distibutor faulty.ignition timing way off or you have worn distributor cap and rotor. worn spark plugs and wires.

jump timing loosen distributor and plus or minus turn and retighten

1. The ignition system on your 5.0L uses a distributor type system and will include the following components:
   1. Ignition control module (ICM). Depending on the year of your specific Ford, it'll have a inner-fender mounted ignition control module or a distributor mounted ignition control module. hot sure which you have.
   2. Ignition coil. you replaced it.
   3. PIP (Profile Ignition Pickup) sensor. This is Ford's name for the crank sensor and is mounted inside the distributor. The most common name for this component is the pick up coil.
   4. Distributor cap and rotor. you replaced
   5. Spark plug wires. you replaced.
2. The thing to keep in mind about the ignition system is that all engine cylinders must get spark and the one thing that will stop the ignition system from creating spark on a wholesale scale is a BAD crank sensor.Have you pulled a plug then using some insulated pliers grounded it to the vehicle and turned it over to see if you have spark, that'll tell you alot.takes two people of course.Best of luck and hope this helps.

BAD COIL OR IGNITION MODULE INSIDE DISTRIBUTOR RUN OHM TESTS TO VERIFY

First does the rotor turn when cranking engine?? possible timing chain is out or stripped gear..are you sure it has no spark??did you verify this with a high output spark tester ? did you spray starting fluid in the tbi unit ?

the crankshaft position sensor located between flywheel and trans is where the power source for the coil comes from. I suggest you need change that

Check for spark at the spark plugs. If no spark, remove distributor cap and inspect the inside of the cap and the rotor for obvious signs of wear or damage. Check for spark at the coil wire by removing the coil wire from the center of the distibutor cap, and, holding the end of it close to the engine block, have someone crank the engine. There should be a very strong spark. If there was spark at the coil but not at the plugs, replace the distributor cap and rotor. If there is no spark at the coil, you either have no power or ground at the coil, or the coil is bad. With the ignition ON, there should be 12v at the red wire for the ignition coil. if not, check the fuses. Check for the pulsing ground signal of the ignition coil at the other wire ( I think a white wire) using a test light clipped to battery + while the engine is being cranked. If there is no light, the problem is likely the ignition module or pick-up coil, which is located in the distributor. Make sure that the wiring and connections are in good shape for these items before condemning them.
Pick-up coil should have about 1500 ω of resistance.
Good Luck

You may have to check loose cables or wiring. Inspect the ignition coil, it should be in series with the distributor.

95 JEEP WRANGLER 4 CYL

No spark. I have changed out the distributor cap, rotor, wiring from coil to cap, and coil was replaced. I checked the distibutor by turning ignition key and observing the rotor turn. What else can I check. I did not observe a module.