MY WARRIOR PICKUP ENGINE WOULD NOT START AND IT HAS CLT TEMP SNSR FAULT AFTER TESTING IT WITH DIAGNOSTIC COMPUTER
SOURCE: self diagnostic test codes
anytime you do the self-diagnostic you will almost always get those 2 codes.
12 - direct power input to the PCM has been disconnected within the last 50 key-on cycles
55 - End of error messages
SOURCE: fault code 0134
P0134 Oxygen Sensor Circuit No Activity Detected (Bank 1 Sensor 1)
Check wiring to Oxygen sensor.
SOURCE: fault code 01652 shift solenoid E intermittent P0674 Intermittent
VW automatics are plagued with valve body problems, check with the dealer for a recall. i cam currently changing all of the solenoids on my 2000 beetle 1.8T.
Hello
The engine
and transmission in this cars drive train are fully
electronically controlled by a computer called the PCM (Power Train
Control Module). Whenever a problem like this occurs the computer
stores a record of the problem (there are of course some exceptions
to this, like the fuel pump, engine coolant teperature sensor and MAF
sensor for instance) in the form of a fault code in its memory, to
read these fault codes you must have the systems memory scanned with
a special tool. Once the fault code(s) are read you then must perform
the appropriate diagnostic testing to find and resolve the problem(s)
DO NOT REPLACE ANY PARTS UNTIL THE DIAGNOSIS & TESTING IS
COMPLETED.
Hello
The engine
and transmission in this cars drive train are fully
electronically controlled by a computer called the PCM (Power Train
Control Module). Whenever a problem like this occurs the computer
stores a record of the problem (there are of course some exceptions
to this, like the fuel pump for instance) in the form of a fault code
in its memory, to read these fault codes you must have the systems
memory scanned with a special tool. Once the fault code(s) are read
you then must perform the appropriate diagnostic testing to find and
resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL THE
DIAGNOSIS & TESTING IS COMPLETED.
594 views
Usually answered in minutes!
I can only jump start it
the engine cranks but does not start
Yes, the battery can cause that. Battery need to be replaced. The battery is not giving enough CCA (cold Cranking Amps) to kick the starter motor over.Try a diffrent battery in your car, you will see
THX I'LL CHANGE THE BATTERY, BUT my L200 warrior pickup had several faults like AIR TEMP SNSR, CLT TEMP SNSR,BOOST SNSR, VGT CONT PRS AND EGP POS SNSR . I HAVE CLEARED ALL SENSORS EXCEPT CLT TEMP SNSR AND THE ENGINE CRANKS BUT WONT START... DO U STILL THINK THE BATTERY IS THE PROBLEM
×