Crank angle sensor location

Question edited for clarity.

Help in the link.

https://www.google.com/search?q=2001+mitsubishi+nimbus+ug.+crank+angle+sensor+location

..

I have a Nissan x-trail with QR20 engine 2005 model.
it's starting but after 20mins it's charting off.
After that it's starting again then drive after 40mins it's charting again.. New camshaft sensor..new crank sensor...new fuel pump new through bokle i need help

Inside timing belt cover

what is A color of wire in nissan x trail cam position sensor 2003 model

2003 nissan petrol xtrail stars some times other times just winds over
have changed crank and cam sensors reset ecu fitted new fuel pump still the same

The cam and crank position sensor can be found in the front of the crank on the engine block below or next to the water pump in many applications.
It can also be located on the main crank pully or the flywheel.

If you have the type of crank angle sensor shown in the image, then it will be located on the bell-housing towards the top of the bell-housing and usually on the drivers side. Dis-connect the faulty crank angle sensor and then un-bolt the two bolts that secure the crank angle sensor to the bell-housing and then remove the sensor. The best access to the crank angle sensor is from under the vehicle.

The sensor is located in the bottom inside of the distributor.

wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.

look carefully on bellhousing and rocker cover/head it has to be somewhere