Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Jan 19, 2018

I have a 2002 chevrolet 1500 . the gauges in dash quit working

The gauges in the dash quit working and is blowing a 10 amp fuse. ive replaced the fuse it worked about a month. and stopped working again now it blows the fuse everytime i crank it. also i had amechanis tell me its also telling the truck its in cruise control. i have replaced cruise fuse dindt help

1 Answer

Jim Ponder

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 11 Answers
  • Posted on Jan 19, 2018
Jim Ponder
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Oct 05, 2011
Answers
11
Questions
0
Helped
1039
Points
34

The circuit board on the back of the gauges is bad. They are known for it.

5 Related Answers

Anonymous

  • 399 Answers
  • Posted on Sep 18, 2008

SOURCE: 2001 Mercury Mountaineer keeps blowing the PCM power diode (fuse #19)

Check all of the battery terminals and cables and check the wires on the starter/selonoid, start from the battery and follow the cable out and check all conections , clean and tighten them and if it still does it the starter/selonoid is bad and needs replacement...

Ad

Anonymous

  • 1066 Answers
  • Posted on Mar 21, 2009

SOURCE: cruise control won't work, 10 amp. fuse in fuse box under hood ok

look at the other fuse box under the dash

Anonymous

  • 28 Answers
  • Posted on Apr 05, 2009

SOURCE: Fuse keeps blowing

Greetings..hopefully we can help or at least isolate the issue. You need to know that there was a few recalls with the cruise control system which is involved.. speedo and odometer is possibly in that circuit..but I am sure the ac had a separate fuse and relay...I do not have a book or schematics here. ,,I would disconect the wires to the ac compressor taking that out of the cause... I would also disconnect the cruise control wire to the unit and drive aroud for a day or so to see what happens. This is whats known as isolate and test . It may take some time but it will give you answers to what is the cause and then check that system out with us. At least you will have it narrowed down...ps ..do not forget at when it happens and what type of roadway ( bumpy, soft, wet, snow) as it all plays a part in diagnostics. I hope this helped.

Anonymous

  • 187 Answers
  • Posted on May 07, 2009

SOURCE: 2002 Acura MDX door lock fuse blows

It sounds like the circuit has a short in it somewhere. You can check for grounding with the same tester your used to measure the amp draw. Connect the tester and put it on continuity, this should sound an alarm when a closed circuit is detected. Move the harness around to see if it goes off.

Anonymous

  • 3 Answers
  • Posted on Feb 12, 2010

SOURCE: I have a 2002 Ford F150. Fuse 15 (5 Amp) keeps blowing.

replace nuetral safty switch for gear shifter and check window relays

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My four-wheel drive is blowing fuses I unplugged the trany the front axel and it still blows

What fuse's ? What all do the fuse's power ? Would need to look at a power distribution diagram ! Need fuse number ! Explain , 4X4 blowing fuse's .

T -case fuse #2 20 amp I/P fuse box , #4 gauges fuse 10 amp I/P fuse box Both of these power control module for 4X4 . 4WD fuse # 24 25 amp I/P fuse box .
1helpful
1answer

I HAVE A 2002 E150 ECONOLINE VAN. THE RADIO, THE HORN, TURN SIGNALS AND ER FLASHER QUIT WORKING.

Could be a lose connection in the dash , more then likely . Who replaced the gauge an drive indicator ? The horn / cruise control /turn signals / radio all share a common ground point it looks like ,G203
G203 Behind upper LH side of I/P, near cowl
Maybe after gauge & drive indicator replacement connection became lose . None of these componets share a power supply (fuse) I can't send picture of the location of G- 203 sorry ! Instrument cluster would need to come out to see the ground .
0helpful
1answer

1998 dodge ram 1500 dash lights wont work

Walker Muffler - Aluminized Steel Direct OE Replacement 1998-2001 Dodge Ram 1500.-------------------------------------------------------------------------------------
SLIM HID XENON light
0helpful
1answer

I have a1988 chev 1500 that blows the 20 amp gauge fuse

I've seen fuel gauge wire from tank sending unit shorted out and blew gauge fuse
2helpful
1answer

2002 chevy cavalier gauges not working - battery was jumped after leaving lights on- gauges quit working after

Start the car. remove the cluster fuse from the fuse panel to the left of the dash. Wait 5 seconds and reinsert the fuse. It should be fine until you replace the battery again.
0helpful
2answers

My 96 blazer keeps blowing gauge fuse which is a 10 amp but it has also blown 30 amp fuses,please help

unplug the instrument cluster. If it now does not blow, replace the instrument cluster. If it stll blows then you need to trace the wire in the loom looking for where it touches metal or have several wires melted together.
0helpful
1answer

93 s10 pu (vin z) cd player quit working then the dash lights

the cd players almost never work in those so i doubt thats related. as far as dash and running light check your accessory fuse in the pana. The are linked. If the fuse blows it all stops working. Usually a 15 or 20 amp fuse
0helpful
2answers

On my 1999 chevy silverado the only gauges that work are the oil pressure gauge and the temperature gauge. nothing else is working cot even the speedometer or the RPM gauge.

The stepping motors in the gauges go bad. Do a search on ebay for CHEVY SILVERADO INSTRUMENT CLUSTER for cheaper repair options, dealer costs $300.00
0helpful
1answer

Fuse for tach

THERE IS A 10 AMP IGNITION 1 FUSE UNDER THE HOOD IN THE PDC.THERE IS NOT A FUSE FOR THE TACH.IF THAT FUSE WAS BLOW NONE OF THE GAUGES WOULD WORK.U COULD USE A SCAN TOOL AND CK FOR TROULE CODES.
6helpful
1answer

Gauges blow fuses,brake and turn signal lights dont work

all my gauges quit working and my turnsignals checked all my fuses under the hood and dash whats my problem?
Not finding what you are looking for?

50 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...