SOURCE: Have a 1999 Oldsmobile Intrigue 3.8l V6. The
Providing your guage is working correctly; look just inside the fan, you should see a wire coming from the fan motor, follow the wire. It will end up at a sending unit that looks similar to a fitting. This is what tells the fans when to turn on.
SOURCE: how do you install a ignition control module in a 1999 Intrigue?
It should be on the front of the engine right by the coil. The coil is the thing which has 1 fat wire going to the distributor. Look at where the wires are that go into the coil, they will lead to the ignition.
SOURCE: I have a 1999 Intrigue 3.5 6 cyl. that needs a ignition module
Most are located under the coil packs. Coil packs are the things your plug wires attach to. They are square looking and should be three of them.Each pack is held by 2 7mm or 8mm bolts,remove and pry gently.Because they sit on two prongs.
SOURCE: instructions how to step by step replace
1999 Oldsmobile Intrigue
IGNITION SWITCH AND LOCK CYLINDER REPLACEMENT
1. Disconnect battery
2. Disable Supplemental Restraint System (Airbags)
3. Remove traction control switch from rear of center console plate
4. Open console lid and remove screws at front of console
5. Pull console plate up to release clips and slide over shifter
6. Pull rearward to release clips retaining instrument panel accessory trim plate to instrument panel
7. Remove screws attaching radio to instrument panel
8. Disconnect electrical connectors and remove radio
9. Take down instrument panel hush panels and disconnect courtesy lights. Remove hush panels
10. Remove knee bolster and knee bolster bracket from driver's side below steering column
11. Remove screws from IPC trim plate
12. Pull out instrument panel cluster trim plate to release from retainers
13. Remove trip odometer and reset switch from IPC trim plate
14. Remove IPC trim plate
15. Remove screws from IPC and pull IPC out
16. Disconnect electrical connectors from IPC and remove IPC from the instrument panel
17. Disconnect ignition switch connectors
18. Turn ignition switch to the ACC position and remove park lock cable from ignition switch
19. Turn ignition switch to ON position
20. Depress and hold locking tab on right side of ignition switch with a small, flat-bladed screwdriver and pull ignition lock cylinder from ignition switch
21. Remove ignition switch bezel from ignition lock cylinder
22. Remove screws attaching ignition switch to bracket
23. Remove ignition switch through the IPC opening
24. To install, reverse procedure
229 views
Usually answered in minutes!
×