How do I remove the drivers side door panel on a 2004 Dodge Intrepid

https://www.youtube.com/watch?v=c-bXmX10Qbw
https://www.youtube.com/watch?v=ZaYnlIaOCT4
https://www.youtube.com/watch?v=ru8_PxrGEVw
https://www.youtube.com/watch?v=BggY3JDDzhQ&t=35s
https://www.1aauto.com/how-to-remove-install-front-door-panel-dodge-intrepid-1998-04-1aauto.com/video/2215

PHILLIPS SCREW DRIVER AND A DOOR PANEL REMOVER TOOL WORKS BEST,ONCE YOU REMOVE ALL SCREWS YOU CAN SEE I BELIEVE THE ARE SOME HIDDEN BEHIND THE SPEAKER GRILL ,TAKE THAT OFF AND THEIR SHOULD BE AT LEAST 3 AROUND THE SPEAKER AREA.ALOT OF PEOPLE DONT SEE THOSE.THEN GET THE DOOR PANEL TOOL PUT UNDER THE DOOR PANEL AND PRY IT TO YOU, MAY HAVE TO USE SOME FORCE THEIR PLASTIC SNAPS. THIER ALL AROUND THE DOOR.....HOPE THIS HELPS

Did you check the drivers side when you open the door there is usually a panel on the side of the dash where the car speaker is

there is something jaming the handle or broken. remove door panel. check to see if or what is jamed bent or broken. easy to repair.

2000 Dodge Intrepid 2.7L SFI DOHC 6cyl Repair Guide
The Flasher is located front seating area, driver side, under left hand side of instrument panel between junction block and brake pedal.

dear friend-i think you must first try to press the switch with the hand and see if it works.you have to remove the panel of the door remove the screws on the outside with a inpact screwdriver,replace with new one.

The flasher relay should be located in the fuse panel on the left end of dasboard which is visible with driver door open and there you will see a panel to remove to gain access.

Door panel will have to come off to repair, most likely has broken door handle or cable/linkage problem.

the fuses when you open up the drivers side door towards the top there should be a panel that you can remove to find the fuses but it may also be a relay that has gone bad in the engine compartment fuses and relay bay or the switch for the windows has gone bad try the driver side switch if it doesnt work try  the switchs for the individual windows on there doors.

The intake where the thermostat goes is in the driver side of the motor behind the altenator. I had to remove the front clip of the car and the altenator to get to it. It is quite a job.