Need to open hood
SOURCE: inop hood latch 1985 corvette
In the windshield wiper area on both sides of the car you will see a rubber plug about 1 inch in diameter. Use a flatblade screw driver (about 8-10 inches) and poke this plug out of its hole into the engine compartment (you can recover it later.) Insert your screwdriver through the hole until you find the release latch. Just push it until it releases.
SOURCE: the hood latch cable on
Remove the honey comb grill from the drivers side and you can reach in and release the hood
SOURCE: 1985 corvette, pulled the hood release and the
have someone push down on that part of the hood while you pull the release. Usually that frees it and it should be adjusted up so it will open again
SOURCE: how do you open a hood on 1976 corvette when cable
If the cable broke in the cabin, pull off the side panel in the footwell and use a pair of channel locks or good pliers to pull on the cable to get the hood open.
If it broke at the hood you'll probably need to lift the car and see how to get to the release by getting between the radiator, front end and grasping the latch.
SOURCE: Good Morning, The hood release broke
there should be a rubber plug right under the front window on either side (the plug on the left can only be removed by removing the windshield wiper) once you have done this use a screw driver to push down on the latch under the hood
372 views
Usually answered in minutes!
×