95 Dodge Ram 2500 5.9 4x4,engine cuts out for no reason.
It seem to be electrical, I have check and replaced the coil,wires, and check grounds and connections as well as vaccum lines. I had oringal had a code for the egr system, it turn out to be the soleniod had a busted pin. I have left the truck running in the yard for about a 1/2 hour and maybe it dies maybe not. I have run out of idea's. On a side not i was told you can use Vasline in plug connections to improve the contact(true or false) The truck runs fine and then it stops for no reason. We also replaced the coils, cables and spark plugs and it keeps stalling for no reasons. we suspect the fuel pump, but it is not shure. we left the truck for a few minutes, and then it starts back again. but there is some hesitations and the engine is shaking a bit.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Dodges have a high rate of failure in the engine ecu. If you can find you 5v supply that feeds the sensors. Ohm it to ground If it dose ohm out (shorted to ground) unplug your ecu and recheck.
ck for the pick up coil working.unplug pick up coil remove wire from ignition coil to dist lay coil wire still connected to coil about 1/2 inch from ground turn key on take a jumper wire and jump the wires on the engine harness side of the connector if it has a spark replace the pick up coil in the distributor
×