Question about Jeep Liberty

1 Answer

Air bag light on

Air bag light stays on. all bags ,clock spring and module have been tested by an air bag specialist. no codes present. signal from module is reaching gauge cluster plug. Have installed another used cluster .light stayed on. are there any other electronic items on the same circuit. What could be causing light to stay on?

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 63 Answers

Is there a bypass switch somewhere that deactivates certain airbags under some conditions, for example when a child seat is present in the front of the vehicle?

Posted on Dec 01, 2017

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 126 Answers

SOURCE: Passenger Air Bag Warning light stays son

is this van new for you ? is it a status light letting you know that the airbag is loaded and ready for anypassenger that you have in your van ? do you have a key that you can turn it off in most vans there is an option to turn air bag on or off depending on size or opinion of passenger . im thinking that if its a status light its okay to be on letting you know its ready for opperation . take a look at your owners manual airbag section . and if it does turn out to be a warning malfunction indicator please dont waste time take it to your local dealer and have it checked out .hope this information helps good luck

Posted on Jul 03, 2008

Anonymous

  • 136 Answers

SOURCE: Air Bag Light stays on every time I start the engine.

There are a few things that can cause this, either the air bag itself going bad, or an airbag sending unit or brain going bad,

Posted on May 05, 2009

emissionwiz

Marvin

  • 85216 Answers

SOURCE: air bag warning light staying on checked fuzes under bonnet ok

In most cases this problem is caused by the rotating ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to follow factory Airbag disarming protocol can result in an unexpected Airbag deployment and possible serious personnel injury or death.

Posted on May 20, 2009

Anonymous

  • 1 Answer

SOURCE: air bag light stays on audi a4 2.8 quatro 1997

is thir a after markit radio

Posted on Nov 10, 2009

tuyen bui

  • 1025 Answers

SOURCE: OBD11tech thinks I have a bad clock spring on my

it's inside the steering wheel
must be careful, because of the air bag.
disconnect the battery and wait for 10 minutes for the air bag capacitor to discharge power.
remove the air bag module from the steering wheel
remove the center nut, then steering wheel
the clock pring is a yellow round piece that fitted inside the steering column. there is a snap ring hold the clock spring in place. disconnect the wiring then remove the clock spring.

Posted on Feb 28, 2010

Testimonial: "Thank you very much for your help. "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to get to the horn swicth on steering wheel of 2000 pontiac sunfire


Pull the air bag module , don't recommend you do that ! Is the air bag light lit on the instrument cluster ? Horn not working an air bag light lit would indicate clock spring problem . Do you know what the clock spring is ?
How cars clock spring works

Did you check the horn relay ? Do you know what a relay is ?

VEHICLE RELAYS Operation Diagnosis

Mar 06, 2018 | 2000 Pontiac Sunfire

1 Answer

Peugeot 807


it is possible the clock spring i agree,it is the common problem of the open circuit at the system

Jan 27, 2014 | Cars & Trucks

1 Answer

1997 honda civic 1.6L DX SRS Air Bag light stuck on after drove throo heavy rain!


A code reader may not access the body computer, but a professional scanner should. You may be able to research the air bag system online and find a way to make the light flash the codes.
I would guess after reading your description one of the front crash sensors got water in the connector and the sensor has failed.

Sep 27, 2012 | Honda Cars & Trucks

1 Answer

I bought a 05 infiniti a week ago but the air bag come on when start the car i need to know what code that is the used car place trys to give me the run around about it can you help me.


I had to take my to Infiniti...code B1049: for open in drivers air bag module. They replaced drivers air bag module and clock spring...there is a third piece associated with that problem, but I did not need it because the light stayed off after they cleared the code

Oct 24, 2010 | 2004 Infiniti Q45

1 Answer

OBD11tech thinks I have a bad clock spring on my 1999 jeep cherokee classic due to my horn not working & the air bag light stays on. Where is the clock spring & how do I change it?


it's inside the steering wheel
must be careful, because of the air bag.
disconnect the battery and wait for 10 minutes for the air bag capacitor to discharge power.
remove the air bag module from the steering wheel
remove the center nut, then steering wheel
the clock pring is a yellow round piece that fitted inside the steering column. there is a snap ring hold the clock spring in place. disconnect the wiring then remove the clock spring.

Feb 28, 2010 | 1999 Jeep Grand Cherokee

2 Answers

Horn wont work but works with the panic button


The computer controls the horn and looks for a signal from the Remote Keyless Entry system or the horn button. Due to the fact that the horn works with the RKE but not when you press the horn button, would cause me to suspect that the Clock Spring mechanism, which is also used to activate the Driver's Air Bag, might be malfunctioning. When the Clock Spring breaks, the computer does not get a signal from the horn button so it can not opperate the horn. If I remember correctly, when the Clock Spring goes out, the Air Bag light on the dash either does not light up for 2 seconds when you first start the vehicle, or it comes on and stays on all the time, which is to let you know that the Air Bag is not functioning, and the primary cause is the Clock Spring. So check your owners manual to see if the Air Bag warning light on the dash is functioning normally. Your local Chrysler dealer can quickly and easily check the function of the Clock Spring, Horn, and Air Bag system, through the use of the DRB scan tool. If it is in fact the Clock Spring that is malfunctioning, the Air Bag module and the steering wheel must be removed in order to replace the Clock Spring, which should be left to a trained professional, that has been educated on the proper handling of the Air Bag system. You wouldn't want to accidentally deploy the Air Bag, as you could be injured. That and Air Bag modules can be expensive to replace.

Sep 01, 2009 | Chrysler Town and Country Cars & Trucks

2 Answers

MY AIRBAG LIGHT STAYS ON.


This means the clcok spring is defecetive take to a shop.

Aug 07, 2009 | 1996 Lincoln Town Car

1 Answer

2000 Dodge Carivan - Air bag light comes on.


Air bag light on ? Have the vehicle checked for DTC'S - diagnostic trouble code's in the air bag control module . That's the way to find out what the problem is . Suggest you take it to a qualified repair shop.

Jan 03, 2018 | 2000 Dodge Caravan

1 Answer

Air bag code


I strongly suspect you have a bad connection or corroded connection at one of your connectors.

Here's the LFC (lamp Fault Codes) for 36:

B1993 36 22 Driver Side Air Bag Circuit Shorted to Ground GO to Pinpoint Test V . B1992 36 24 Driver Side Air Bag Circuit Shorted to Battery or Ignition GO to Pinpoint Test W . B1994 36 26 Driver Side Air Bag Circuit Resistance High GO to Pinpoint Test X . B1995 36 28 Driver Side Air Bag Circuit Resistance Low GO to Pinpoint Test Y .


eea36a4.gif

Feb 18, 2009 | 2000 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...