Show pitcher of location of crank shaft sensor
SOURCE: crank shaft sensor. where is it located on a
behind the engine on the top passenger side of the engine. 2 13mm. bolts.goes through the bell housing.
SOURCE: where are the cam sensor and crank sensors located on my car?
Crank Sensor: Passenger side of transmission just to right and above the differential cover. Has 3 wires:
Light Blue/Dark Blue stripe - Signal
Dark Red - 8v supply
Black/Light Blue stripe - Ground
If the car runs or cranks, you can test this sensor by first checking for power on RED wire with key ON. Should be 8-9.5 volts DC. Furthermore, connect a dwell meter to the
signal wire by probing the back of the connector. Dwell reading should
be 49-51%. If not, its likely bad.
If you remove the sensor, you MUST replace the paper spacer on the end
of the sensor or you risk damaging the sensor or even the torque
converter drive plate otherwise. Also make sure O-ring is in good shape and positioned properly.
Cam Sensor: Facing Engine, it is on the driver side timing case housing, on
top of the round part, just to the right of the fuel rail pipe where there is a capped
fuel valve.
Has 3 wires:
Tan/Yellow stripe - Signal
Dark Red - 8v supply
Black/Light Blue stripe - Ground
Testing is same as for Crank Sensor.
SOURCE: where is the crank shaft sensor locate on a 1998
Should be bolted right before the transmission (it has a wire connected to the harness) on the upper side of the engine (near the interior). See Chilton manual 20404.
24 views
Usually answered in minutes!
×