Do I need to reset the panel with new battery installation?

With ignition off press and hold left hand instrument panel button switch ignition to 1st position reset should show on the inst panel , with button still depressed the reset should flash release and then press this should then give you new service schedule and mileage switch ignition off.

run the fault codes first to see if there are any codes, next is to use the scanner to reset the ECM program
Lastly is to check the wiring circuit to ensure that you have not by-passed a control that stops the battery from going flat.
Lastly have a load test done on the battery because the gauge shows full voltage , batteries can fail under a load such as starting.

same as mine needs reseting did you disconect the battery if not it will show as a fault i forgot to disconect mine and the srs light is on all the time can buy a reset tool from ebay for less than taking it to garage and getting them to do it hope this helps

You shouldn't need to clear the engine codes after installing a new battery. If the light is on, after starting and driving the car 5times the light should go out. But if you want to reset the engine light then go to a part store and buy a scan-tool. Actron is one company that is inexpensive. Look them up first (Google it) and decide what you want to spend verses what you want it to do.

Hi 1987 Honda Civic lihgts on instrument panel. New Battery. and replaced blower unit but lights on panel not working. I am yet to install stereo unit which was taken out by previous owner - very roughly ! Wondering if not having stereo will effect instrument panel lights. Cheers Steve

The is usually an off/on button located in the rear cargo area behind one of the side access panels.

Also, Your Lincoln may still be under warranty because the Lincoln products have a longer warranty that comes with the vehicle.

Start with the fuel cutoff......sometimes they need to be reset. Step 2 would be the the fuel relay.........I doubt that the fuel pump is not working as you said you can hear it engage. Let me know if you need anymore help.

Thx
Ken

hi by the sounds of it the imobiliser is on try disconnecting battery leave so it discharges the ecu then try starting it if this fails then it may need to go to dealer to be reset by computer

if the light doesnt come on for the heated seat, *sometimes* the electronics need to be reset. You do this by very carefully taking both battery poles off the battery entirely. Then touching the negative to the positive WHILE NEITHER IS TOUCHING THE BATTERY (this is very important otherwise you could get shocked). This will clear computer and reset it. Then reconnect the positive first. then the negative. this will sometimes work. This is only if the light for the heated seats is not coming on. If the light is coming on you probably need a new heater core.

you have to clear all the codes first, your vehicle stored fault even when the battery was replaced it created trouble codes. have it reseted and see if it comes back on.
let me know