SOURCE: 1998 chevy truck 1500 door latches
The handle mechanism wears over time. I went on eBay, bought a color matching handle for under $20 and replaced it myself. You have to be careful when removing the plastic panel bezel that surrounds the handle, drill out two rivets and your door will open like new!
SOURCE: Stuck door latch 98 K1500
never shut the door to test and always remove ign key as sometimes door lock automaticly,as to why doors will not open did you refit the connection from handle to the lock little metal rod with a plastic clip to hold it on ??assuming it has one as i have never seen a chevrolet only an astro van here in spain .to test without shutting door use a screwdriver to close the mechanism .sorry i couldnt be more helpful
SOURCE: i have a 2001 chevy
Same problem here. I finally got it after soaking the bottom latch with WD40 for a week. I ended up cutting the bottom rubber seal OFF below the latch. With a BMF screwdriver and hammer and three swings...it opened. The bottom of the latch has an "L" shaped metal guide-this is not the latch. Beside that, towards the rear of the truck, is the latch. The bottom part of the latch must be forced towards the cab and upwards at about a 45 degree angle. After removing the part I could see that it couldn't be unlatched from the inside no matter how much lubricant, heat, cussing or beer drinking I did. TOTAL COST: Latch-about $58 dollars (dealer item only)
Rubber seal- $25 or so
Beer-$22
SOURCE: 1998 chevy silverado door latch will not open
sounds like the linkage is disconnected from the latch unit. Becessary to remove the door trim to inspect and repaiir. Hope this helps
SOURCE: 2002 Chevy S10 Third Door Won't Open
I have a 02 s 10 with a stuck bottom 3rd door latch. I took my seat balts loose removed the door panel,also removed the plastic latch yoy use to open door, the top latch was alredy opened and I put a needle nose vise grip on the lever going to the bottom I used to much and broke the little plastic retaing piece that holds the lever.I looked inside door with light saw my latch was in open pos and took pry bar to pry botton door from inside,once opened i used a 10 mm 1/4 in drive to take out 4 bolt's to latch.removed latch placed in vice and heated with burnsomatic torch,the latch is coated with a plastic so i burned it all off with vice grip on the lever to open and pliers the work the part that catches door striker I kept working it until it freed up then put antu seige on put back in truck. I recomend buying a new latch and put anti seize on it. that's my plan but at least it's working for now. or get a good used one from a junk yard. you can e mail me at [email protected] for ant Q's
288 views
Usually answered in minutes!
×